Dog trace d-control 640 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Засіб для догляду за домашніми тваринами Dog trace d-control 640. Dog trace d-control 640 15 сторінок. Electronic vibration training collar
Також для Dog trace d-control 640: Посібник (18 сторінок)

Dog trace d-control 640 Інструкція з експлуатації
– Medium charged battery
– Flat battery
If the battery is flat, insert new AA alkaline batteries into the battery compartment.
Make sure that the receiver works correctly.
TIP: The battery can be taken out easily by small screwdriver, which is placed
carefully under the the battery edge.

6.2 Switching the transmitter ON/OFF

Switching ON: Press down for 1 second the
display indicates that the unit is active.
Switching OFF: Again, press down for 1 second the
7

7.1 Battery insertion and replacement in the receiver

1. Screw out 4  screws from the battery cover using a  cross-head screwdriver and
remove the lid.
2. Insert the lithium CR2 3V battery into the battery compartment with a  correct
polarity (according to the polarity indicated with the "+" symbol in the battery
compartment – see the picture). A  wrong
polarity may damage the unit.
When you insert the battery for the first time, or if
the battery is removed longer than a  few tens of
minutes, you will hear an audible beep tone
indicating the correct installation of the battery.
Note: When you replace the battery quickly, you
may not hear the audible beep tone of the collar.
3. Make sure that the rubber seal is clean and
correctly seated in its groove. Clean any dirt
from the seal.
4. Put the battery cover of the receiver back and
screw in the 4 screws adequately.

7.2 Checking the battery status

The status of the battery is indicated by LED indicators on the side of the receiver.
(see chapter: 5 Product description – Receiver)
The batterry is fully charged – when switched on, green LED is flashing
The battery is low – when switched on, red LED is flashing

RECEIVER PREPARATION

button on the transmitter. The LCD
button on the transmitter.
Battery polarity mark
21