Dog trace d-control easy Інструкція з експлуатації Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Засіб для догляду за домашніми тваринами Dog trace d-control easy. Dog trace d-control easy 18 сторінок. Electronic training collar
Друкувати сторінку
Programming (matching) of the remote controller and the receiver
Every remote controller has its own RF operational code. Programming of the remote controller with
the receiver (collar) will be take place during the fi rst use of the DOGtrace™ d–control set or with
a new remote controller or a receiver (when former or latter is lost). This operation will enable you to
match your remote controller with the delivered receiver (collar).
IMPORTANT: Before programming is started (before using your receiver for the fi rst time
or before code rewriting) make sure that no one else uses his/her d–control or another
product made by DOGtrace in your neighbourhood – your receiver might randomly
receive the code from another remote controller and set itself to it. If this happens,
program your receiver once again, using your remote controller.
Turn on your transmitter.
Touch the lower part of your remote controller to the target on your receiver (see the photo on
page 8). The green LED will be permanently lit and after some 6 seconds, it will switch to the
programming mode, indicated by permanent fl ashing of the red LED.
Now take your transmitter away and press down the sound signal button
remote controller. The codes will be matched in this step and your receiver will produce
a sound signal.
on your
9