Dogtra Edge Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Засіб для догляду за домашніми тваринами Dogtra Edge. Dogtra Edge 19 сторінок. Remote controlled dog training collars
Також для Dogtra Edge: Посібник користувача (19 сторінок), Посібник з експлуатації (14 сторінок), Посібник користувача (20 сторінок), Посібник з налаштування коду (2 сторінок)

4. How to find the right stimulation

The EDGE unit comes installed with the rheostat dial on the transmitter.

The rheostat intensity dial controls the stimulation level, with level 1

being the lowest level and level 127 being the highest. Switch to the

included selector style intensity dial with 8 levels of stimulation, with

1 being the lowest level and level 8 being the highest. The level of

stimulation best suited for your dog depends on your dog's temperament

and threshold for stimulation. Always start at the lowest level and work

your way up. The appropriate level can be found when the dog responds

to the stimulation with a mild reaction, such as a tensing of the neck

muscles. The stimulation level may vary depending on the training

situation. When highly distracted, dogs will require a higher level of

stimulation.

The Dogtra EDGE has a 1-mile range. The range may vary depending

on the way the transmitter is held. Hold the transmitter away from your

body to receive the greatest range. For maximum signal strength, keep

the Dogtra EDGE properly charged.

Maximum range

*Avoid touching the antenna or the range may decrease substantially.

Typical range

Minimum range

The LED indicator flashes every 4 seconds when the receiver is on and

ready for use. The LED indicator will blink on both the transmitter and

the receiver when the transmitter buttons are pressed.

The LED indicator color indicates the battery life level.

Green = Fully charged, Amber = Medium, Red = Needs charging

If the unit is used while the LED indicator is red, it will shut down

automatically.

1. Lift the rubber-charging cap and plug in the charger.

2. Plug the adapter's power plug in to a standard AC wall outlet. The

LED indicator on the transmitter and receiver/collar will turn red.

3. When the unit is fully charged, the LED indicator will turn green on

both the transmitter and receiver/collar. Unplug the adapter's power

plug from the AC wall outlet and disconnect the charger from the

unit.

4. Place the rubber-charging cap back over the charging port.