cymatic audio LR-16 Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Обладнання для запису cymatic audio LR-16. cymatic audio LR-16 20 сторінок. Line recorder
16 track digital direct-to-usb recorder 16x2 usb audio interface
Також для cymatic audio LR-16: Посібник із швидкого старту (8 сторінок), Посібник із швидкого старту (8 сторінок)
Друкувати сторінку8.6.
Stop the recording
To stop the recording, press the Stop button. The Play and Record buttons will flash for a few
moments and the display will display "Please wait" until the LR-16 has finished writing all data to
the storage device.
Warning! Do NOT remove the storage device while
the Record and Play buttons are still flashing. Your
recording might become unusable if you do so.
8.7.
Playing back the recorded tracks
Use the Next / Previous or Up / Down buttons to step through the existing recorded tracks on the
attached drive.
Press the Play button to start playing back a track. The stereo mix down of the multi-track recording
will be played out of the stereo headphone output, as well as the rear-panel stereo Line output.
To change the levels and panning of each individual channel, as well as mute/solo individual
channels, please refer to the section "Monitoring settings".
8.8.
Recording priority
No matter what mode the LR-16 currently is in (Recorder mode or Player Mode), pressing the
Record button will always cause it to instantly go into recording mode and start a new recording.
While recording, all buttons except for the Record and Stop buttons are blocked from use.
PRODUCT MANUAL
14
DIRECT TO USB RECORDING
8.9.
Recorder Menu
Pressing the Menu Button while in recording mode will take you to the Recorder Menu. This
menu contains assorted settings that affect the operation of the LR-16 when it is operating in
recorder mode.
Use the Next / Previous buttons, or alternatively the Up / Down buttons, to navigate to the desired
configuration, which will be highlighted on the display.
Press the Select button to adjust the highlighted selection.
The display will switch to the specific settings for that selection, as detailed below:
8.9.1.
Recorder Configuration
This screen allows you to configure the LR-16 to record the desired number of tracks.
Choices include the 16 tracks (the default setting), as well as 2, 4, or 8 tracks.
Use the Up / Down to highlight the desired number of tracks, then press the Select buttons to
make the selection.
When a new recording has started, the recording screen will momentarily display the configured
number of tracks being recorded at the bottom of the screen, as a reminder. The bottom of the
screen will then be replaced by the metering display.
DIRECT TO USB RECORDING
PRODUCT MANUAL
15