Akrobat PRIMUS FLAT Посібник з встановлення та експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Спорт & на свіжому повітрі Akrobat PRIMUS FLAT. Akrobat PRIMUS FLAT 17 сторінок. Trampoline 17 x 10 ft
Також для Akrobat PRIMUS FLAT: Посібник з встановлення та експлуатації (10 сторінок)

Друкувати сторінку

Attaching the PVC retaining panels

The next step is screwing the PVC retaining

wall panels to the frame. You will need the

cross-head screwdriver and gloves. Take one

panel and place it against the outside of the

frame. You will find four holes in the frame and

four holes in the wall panel. Insert and tighten

the four screws to attach the panel tightly to

the frame. Repeat with all remaining panels.

Digging the trampoline pit

Position the frame on the location you chose and mark the position on the ground. It's best to mark

out a hole a bit wider than the diameter of your trampoline.

This will make it easier for you to put the frame in and find the right level. Dig the pit to the

following dimensions:

TRAMPOLINE SIZE

Dimension A – Outer hole

The hole should not accumulate water (in which case the drainage is necessary) and it should be

possible to clean during maintenance.

First, dig the outer hole to create a ledge for

your trampoline frame, which needs to be 10''

deep. This is the exact frame height, so

that the safety pad on top of the frame will

be just above the grass level. Continue by

digging the inner hole.

AKROBAT HINT:

It's a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a

mini digger to excavate most of the soil and leave you with the finishing touches.

Note: You will need to save some of the soil for later.

INSTALLATION AND USER MANUAL - PRIMUS FLAT

Dimension B – Inner hole

10 ft

12 ft

14 ft

10''

/ 8''

Dimension C – Total depth

8'8''

10'8''

12'8''

Dig the inner hole according to the

dimensions of your trampoline and with a

bowl-shaped bottom. The inner hole should

be 1'4'' narrower than the trampoline size.

This will leave a 8'' ledge all around on

which the trampoline will sit.

2'6''

2'11''

/ 10''

/ 8''