DogWatch System 1200 Інструкція з експлуатації Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Засіб для догляду за домашніми тваринами DogWatch System 1200. DogWatch System 1200 9 сторінок. System
Також для DogWatch System 1200: Посібник з монтажу (10 сторінок), Інструкція з експлуатації Посібник з експлуатації (16 сторінок), Посібник користувача (12 сторінок)
Друкувати сторінку
R1200 Receiver
Adjustable
Nylon
Collar
Battery Cap
3.6 Volt Battery (R1200)
The lightweight radio receiver worn by the dog identifies a coded FM radio signal
from the boundary wire. The receiver emits an audible warning followed by a correc-
tion stimulation if the dog comes too close to the boundary wire. The R1200 oper-
ates on a replaceable battery and is waterproof when the battery cap is fully seated.
System 1200 Receiver Features
Adjustable Collar: The receiver is attached to an adjustable nylon collar. The collar
should be positioned above the dog's regular collar. Your DogWatch dealer will adjust
Figure 1.
make contact with the skin in order for the dog to feel the stimulation. In certain cases, it
may be helpful to clip some of the hair around the contact posts so that the posts can
touch the skin more easily.
Tighten the contact posts only with the collar wrench provided. Use of pliers or similar
tools can result in over-tightening, which can damage the receiver.
Antenna: The receiver incorporates an omni-directional antenna design. The use of mul-
tiple antennas in the receiver assures optimal reception from the signal field.
R1200m Battery: The R1200m receiver is powered by a 3 volt (1/3 N) lithium battery.
The receiver is designed for a battery life of up to 6 months. The negative (-) end of
the battery must be inserted down. (Figure 2)
R1200 Battery: The R1200 battery is powered by a 3.6 volt lithium battery. The
receiver is designed for a battery life of up to two years. The positive (+) end of the
battery must be inserted down. (Figure 3)
Contact Posts
Metal Lock
Washer
CollarBone
Test Light
Magnet
Hold Magnet Between Two Lines
the collar to insure that the contact posts touch
the skin on the dog's neck. ( igure 1.) Check
the fit for the first few days of wear to insure that
the collar is not too tight or causing irritation to
your pet's neck. It is strongly recommended
that you remove the collar at night while your
pet is inside.
Contact Posts: Your DogWatch dealer will deter-
mine the correct set based on your dog's neck
shape, coat, and skin sensitivity. The posts must
- 2 -
R1200m
Insert battery NEGATIVE end down.
Figure 2
Battery Plans: Ask your DogWatch Dealer about a battery plan. If your DogWatch
Dealer does not offer a battery plan, you can join the DogWatch Battery Program,
where a new battery is mailed to you every 6 or 24 months, depending on the type of
receiver you own. Call DogWatch at 800-793-3436 or join through the website at
www.dogwatch.com.
T T e e s s t t L L i i g g h h t t : : The test light allows you to test the
receiver. Hold the test light over the contact posts.
(see illustration at left). and carry the receiver into the
signal field. When the receiver picks up the signal
from the boundary wire, the audible warning will
sound and the test light will come on.
A A u u t t o o m m a a t t i i c c S S h h u u t t d d o o w w n n : : The DogWatch system is
designed to protect your dog from an over-correc-
tion in the unlikely event that your dog walks into
the signal field. If your dog does not exit the signal field, the receiver will automatical-
ly stop correcting after 15 seconds – protecting your dog from over-correction. The
dog will also receive a "warning" correction every 15 seconds which will continue
until he leaves the field.
R R e e c c o o m m m m e e n n d d e e d d R R e e c c e e i i v v e e r r S S e e t t t t i i n n g g s s
System 1200 incorporates 4 training levels plus an audible only setting. Level 1 is a
very low correction setting that in many cases is an appropriate training level for timid
pets. Levels 2 and 3 are progressively stronger training levels. Level 4 is designed
specifically for pets that require higher correction levels in order to be contained. Your
DogWatch dealer will set the receiver to the appropriate training level for your pet.
All settings are designed to be Pet Friendly™ and will not harm your dog.
To change the setting of the receiver, hold your test light magnet to the end seam of
the receiver between the two raised lines on the side of the receiver (as shown on
page 4). Hold the magnet steady and you will hear a series of beeps as the Training
Level advances. The Training Level will continue to advance as long as the magnet is
held in position, advancing to Training Level 1 (Low: 1 beep); Level 2 (Medium: 2
beeps); Level 3 (Medium High - three beeps) and Level 4 (High: 4 beeps). The beeps
represent the Training Level the receiver is set to.
When you reach the desired Training Level setting, pull the magnet away from the receiv-
er. The receiver is now set. N N o o t t e e : : Any time the magnet activates the receiver, it will
advance the receiver setting to the next Training Level, and continue to cycle through the
settings in the order shown in the table below, as long as the magnet is held in place.
Insert battery POSITIVE end down.
Figure 3
- 3 -
R1200