Doheny's 7833 Інструкція - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція для Освітлювальне обладнання Doheny's 7833. Doheny's 7833 3 сторінки. In-ground solar reel
Друкувати сторінкуA Installing the Wheel Handle to the Base:
1. Insert the Elastic Straps into the grooves.
a. Groove for the straps will not align throughout
the Solar Reel (see Figure 1).
b. Each Elastic Strap should be evenly placed on
the Tubing to provide support for the Cover.
2. Slide the large Tube Adapter into the T-Base.
Figure 1
3. Insert the Dowel into the Tube Adapter
Note: The pedal should be at a 90 degree angle
from vertical. This will lock the Tube Adapter in
place when turned downwards (see Figure 2).
Figure 2
4. Slide the Wheel Handle onto the top of the Base.
a. The Wheel Handle needs to be inserted on the
side with the most axle exposed.
b. You will need to line up the screw hole in the
handle with the pre-drilled hole in the Tube
Adapter Axle (you should be able to see through
the handle and axle).
c. If you are having difficulty with Step 4b, you may
need to use a rubber mallet.
5. Insert Screw M5X80 and screw it into the Wheel
Handle, followed by the M5 Closed Nut.
10411 80th Avenue Pleasant Prairie, WI 53158 | Orders and Customer Care: 1-800-574-7665 | Fax: 1-800-323-5932 | Doheny.com
B Installing the Tube Adapter to the Base:
1. On the opposite side of the Wheel Handle, insert
the Tube Adapter to the top of the Base.
2. Slide the Dowel in place into the Tube Adapter.
3. Place the Washer into the Tube Adapter.
4. Insert Screw M5X40 into the Tube Adapter and
screw it into place.
5. Screw M5 Open Nut into the bottom of M5X40 Screw.
6. Slide the Cap into place (may need rubber mallet).
C Installing the Tubes:
1. Insert the Small Tube on to the Tube Adapter. Make
sure the (3) screw holes on the tube ends are
exposed on each end of the tube that go into the
Tube Adapter.
2. Insert the Large Tube, followed by the second
Small Tube using the same process in the above
Step 1.
3. To secure the Tubes to the Adapter, insert (3) 1-3/4 in.
Screws into the Tube Adapter on both ends. Use a
drill to tighten (see Figure 3).
Figure 3
4. Screw (3) 1/2 in. Screws into both Tubes using a
drill to tighten (see Figure 4).
Figure 4