ASG ASG-D17 Посібник з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Викрутка-шуруповерт ASG ASG-D17. ASG ASG-D17 10 сторінок. Mini digital torque wrenches and screwdrivers
Друкувати сторінкуASG Mini Digital Torque Wrenches and Screwdrivers
Operation Manual
Display and Button Functions (Cont.)
When the tool is on, the LCD display will show the TARGET TORQUE, the UNITS, the
MEMORY PRE-SET# and whether the tool is set to TRACK or PEAK HOLD. When the
tool is in use, the display will show the actual torque being applied. In peak mode the
display will hold the last torque reading achieved.
The TARGET TORQUE is the torque you wish to apply to the screw. In the example
above the target torque is 25.00 Newton meters. The default will be the maximum
torque for that particular tool.
The TORQUE UNITS show what scale the tool is currently reading
NOTE: Wrenches will display torque in N.m, lb.ft, lbf.in and kgf.cm. while screwdrivers
will display torque in cN.m, lbf.in and kgf.cm.
M1 means the tool is showing MEMORY PRESET #1. There area total of 9 MEMORY
PRESETS available. M1~M9
T means the tool is in TRACK MODE. (P would mean the tool is in PEAK MODE)
LOW BATTERY INDICATOR If the battery is low a battery symbol will appear below the
M in the memory preset # indicating the battery needs to be replaced.
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
44110-3898
| Phone: (
| Fax: (
| Email: [email protected] | Web: www.asg-jergens.com | Revision: 11/14/2019 | Page 4 of 10
888) 486-6163
216) 481-4519
Setting the Target Torque
NOTE: The torque value on the display can not be set to less than 10% of the
maximum capacity of the tool. When decreasing the torque value below 10% of
the maximum capacity of the tool the display will "roll over" to show the maximum
capacity of the tool.
When using the tool you can choose to set the target torque to the maximum
allowable torque. You will get a warning that the safe limit of the tool is being
approached. Or you can set the target torque to alert you that you have achieved the
desired torque.
When [Er0 ] appears on the display it means the tool has
been over-torqued and will require repairs.