ASG BTL-15 Посібник користувача
Переглянути онлайн або завантажити pdf Посібник користувача для Електроінструмент ASG BTL-15. ASG BTL-15 3 сторінки. Dc 20/30 v
Також для ASG BTL-15: Інструкція з експлуатації (2 сторінок)
Друкувати сторінкуNote
•
This electric screwdriver is designed for indoor use only. Please do not use it outdoors or in a wet environment to prevent the
danger of electrocution
•
Pay attention to the voltage specification. Make sure the switch is in the OFF position when you plug in the power
•
Unless you are a trained maintenance personnel, do not disassemble the device lest it causes dangers or more damages
Operating Instructions
•
Make sure the power is switched off to install or replace screwdriver bits; pressing the front-end iron cap will allow the screwdriver
bits to be inserted or released
•
It is recommended to suspend the electric screwdriver by a flexible balancer for easy operation and prevent its dropping
•
Adjust the torque dial to the proper position according to the dial/torque table for each model
•
The forward/reverse switch should be set to the forward position when fastening screws. Press the start switch to complete the
operation. The automatic control model will shut off the power and stop the rotation of the screwdriver bit as soon as the set torque
value is reached
•
Position the forward/reverse switch to reverse to loosen screws
•
Use hands to hold the electric screwdriver during operation. Keep it in a perpendicular position with the screw and apply pressure
slightly to prevent slipping
•
Use hands or other means to fix the object operated and operate the electrical power screwdriver safely
•
Do not switch the forward/reverse position when the motor is running to prevent the short-circuit of the start switch
•
To ensure long life, use it under the normal operation frequency (8 working hours per day and fasten 800-1000 screws per hour)
•
Please do not use this type of electric screwdriver to fasten wooden screws
Power Supply
•
The BTL-05, BTL-10 and BTL-15 brushless electric screwdrivers can be used with
switching power supply BTL-5A or PS-55
•
The electric screwdriver connects to the power supply with 5P connecting wire
•
Insure that the power supply is connected at 90-240V 50/60Hz, and turn on the
power
•
By turning the HI/LOW switch, user can adjust the speed of the electric
screwdriver
•
When using the PS-55 power supply, the screw counter STC-02 and Soft Start
feature will not function
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
Phone: (
| Fax: (
888) 486-6163
216) 481-4519
Email: [email protected] | Web: www.asg-jergens.com
BTL Series Electric Screwdrivers
BTL-05, BTL-10, BTL-15
User Manual
44110-3898
Switching Power
Supply
BTL-5A (65710)
© 2015 Jergens, Inc. All Rights Reserved | Revision Date: 2/2/2016
PS-55 (65700)
Page 1 of 3