CYP CH-521RXHS Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Конвертер мультимедіа CYP CH-521RXHS. CYP CH-521RXHS 20 сторінок. Hdmi video scaler over cat5e/6/7 with lan/ir/rs232/bidirectional poe receiver
Друкувати сторінку
6.2 Rear Panel
DC 24V
POWER
1
2
1
Power LED: This LED will illuminate when the device is connected to
a power supply.
2
DC 24V: Plug the 24 V DC power supply into the unit and connect
the adaptor to an AC outlet. Only one side of power is needed to
activate both Transmitter and Receiver when both obtain the PoE
function.
3
RS-232 OUT: This slot is to connect with D-Sub 9-pin cable from
device equipment for receiving RS-232 commands.
4
LAN: Connect to an active network for LAN sharing of a total
transmission rate up to 100Mbps. Or when a compatible LAN
equipped Transmitter is connected to an active network, this
allows the network access (including internet access if available)
to be shared between the Transmitter and Receiver. Connect any
Ethernet equipped device e.g. a Smart TV or games console to
the LAN port for that device to share the network internet access.
Note: DO NOT connect this slot with any of the CAT5e/6/7 port.
Doing so may trigger power shoot down and ruin the device.
5
IR Blaster: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
6
IR Extender: Connect to the supplied IR Receiver cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
7
MODE LED: This LED will illuminated when the power is connected.
8
Link LED: This LED will illuminate when the slot has been connected
to the Transmitter and the Transmitter has connected with sources
that shows image on screen.
9
CAT5e/6 IN: Connect to the Transmitter unit with a Single
CAT5e/6/7 cable for receiving all data signals.
RS-232 OUT
3
LAN
IR
IR
Blaster
Extender
4
5
6
CAT5e/6/7 IN
MODE
LINK
7
8
9
4