Close Comfort Focus Enhancer Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Кондиціонер Close Comfort Focus Enhancer. Close Comfort Focus Enhancer 5 сторінок. Personal

Друкувати сторінку
3
REMOTE
(COOL FOCUS MODELS)
Cooling
Fan
Sleeping
Timer ON/OFF
Temperature
Automatic air
AUTO
flow speed
High speed
HI
Medium speed
MED
LO
Low speed
SETTING KEYS FOR ROOM TEMPERATURE
The set temperature will rise by 1°C when the ▲ key is pressed once and the set tem-
perature will fall by 1°C when the ▼ key is pressed once. Note: This sets the targeted
room temperature. If the room temperature is lower than the set temperature, the
compressor will stop. The temperature of the cool air is dependent on the environment
temperature and humidiity, usually 8 to 14 degrees less than the ambient temperature.
SLEEP KEY
When this key is pressed, the air flow of the unit changes into sleep mode (low speed).
1) Press "SLEEP" to set sleep function. Press again to cancel sleep function.
2) The temperature will increase by 0.5°C after half an hour and 2°C after 2 hours.
3) When you turn off the unit, the sleep function will be cancelled automatically.
TIMER KEY
TIMER OFF: The timer-off is used to turn off the unit automatically after the setting
time is over.
1) Press the "TIMER" key to set the time desired.
2) Once the setting hour has come to an end, the unit will turn off automatically.
3) Press the "POWER" key before the time out, the setting time will be cancelled and
the unit will turn off
AUTO KEY
Automatic fan speed. When the ambient temperature is 2 or more degrees higher
than the set room termperature, the unit will run at high fan speed. it will automatically
swtich to medium and low when the ambient temperature gets closer to the set
temperature.
AUTO
C
FUNC
SLEEP
MED
POWER
SETUP
1) After removing the air conditioner from the box, place in an upright position.
IMPORTANT
Always keep your air conditioner upright. It may have been stored or transported on
it's side or laid flat by mistake, so please stand it upright for at least 12 hours before
plugging it into power and turning it on. Failing to do so may damage the unit.
2) Remove the cable from the Cable drawer section at the rear of the unit and plug
into desired power source. Make sure to insert the tank section back in so it is flush
with the rest of the unit. The unit will make a "beep" noise when plugged into
power.
3) Open the Warm air cover fully. This will turn on the unit and the compressor will start.
4) Open the Cold air cover and allow 2 minutes for the air coming out to feel cold. Use
the remote control to adjust fan speed. Keep the temperature setting at 17°C unless
air flow feels too cold
5) Keep a door or window open so fresh air circulates unless it is extremely hot or
windy outside.
6) Avoid using a fan nearby as it can disrupt Close Comfort's gentle air flow.
7) The Focus Enhancer can be used to extend the range of cooling and enable a higher
angle of air flow. Note: The Focus Enhancer comes pre-installed on all COOL FOCUS
models and an optional accessory for EASY FOCUS models.
Drape a curtain as shown to
For a small room, place
exclude light when sleeping.
the unit near an open
window or doorway.
For sleeping, arrange your unit about 15cm from the
end of the bed. Both the cold air cover and Focus
Enhancer can be adjusted to the desired angle so the
cool air flows over you. It can also be suited to larger
beds for two people.
Keep your air conditioner close
enough for comfort. The ideal range
of distance is 1.5 - 3 meters. Arange
the angle of the cold air cover so
cool air flows around face and
shoulders.
Use the optional Igloo Tent accessory
for a more intense cooling effect and
insect protection. We recommend
using
the
igloo
tent
if
indoor
temperature
is
consistently
over
27-29°C
4