CYP 5-Play HDBaseT PU-507WPRX Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач CYP 5-Play HDBaseT PU-507WPRX. CYP 5-Play HDBaseT PU-507WPRX 16 сторінок. 5play hdbaset wall plate receiver (inc. poc & single lan, up to 100m)
Також для CYP 5-Play HDBaseT PU-507WPRX: Посібник з експлуатації (12 сторінок), Посібник з експлуатації (16 сторінок)
Друкувати сторінку
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Receiver Front Panel
1
IR 1 EXTENDER: Connect an IR Extender cable for IR signal reception.
Signals received will be transmitted from any IR blaster connected to
the transmitter unit. Ensure that the remote being used is within the
direct line-of-sight of the IR Extender.
2
IR 2 BLASTER: Connect an IR Blaster cable for IR signal transmission.
IR signals received by an IR extender connected to the transmitter unit
will be transmitted by this blaster. Place the IR Blaster in direct line-of-
sight of the equipment to be controlled.
3
RS-232 OUT: Connect to the device that is to be controlled (via D-sub
9-pin female cable) by RS-232 commands.
4
LAN: Connect to an active network for LAN serving. When the
transmitter or any compatible LAN equipped receivers are connected
to a network, this allows the network access (including internet access
if available) to be shared between the receiver and all connected
receivers. Connect any Ethernet equipped device e.g. a Smart TV or
games console to the LAN port of a receiver for that device to share
the network/internet access.
5
HDMI OUT: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
6
POWER LED: This LED will illuminate when the device is connected to
a power supply or powered by another unit via PoC.
7
LINK LED: This LED will illuminate when both the source connected
to the transmitter and the display connected to the receiver are
connected.
8
IR 1
EXTENDER
IR 2
BLASTER
RS-232
OUT
1
2
3
LINK
POWER
LAN
HDMI OUT
4
5
6 7