CYP CH-507RX Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач CYP CH-507RX. CYP CH-507RX 16 сторінок. Hdmi over cat5e/6/7 transmitter and receiver
Також для CYP CH-507RX: Посібник з експлуатації (11 сторінок), Посібник з експлуатації (16 сторінок)
Друкувати сторінку
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
Front
HDMI In
HDMI In
1
1
2
2
1
HDMI In: Connect to HDMI source equipment such as a DVD or Blu-ray
player.
2
LAN: Connect to an internet or network connection.
3
RS-232 In: Connect to a PC or laptop with D-sub 9-pin male cable for the
transmission of RS-232 commands.
4
Power LED: This blue LED will illuminate when the transmitter is
connected to a power supply.
5
DC 24V: Plug the 24 V DC power supply into the unit and connect the
adaptor to an AC outlet.
Note: Only the Transmitter unit needs to be powered and can power the
Receiver unit via PoC.
6
IR1 Blaster: Connect to the IR Blaster cable for IR signal transmission.
Place the IR blaster in direct line-of-sight of the equipment to be
controlled.
7
IR2 Extender: Connect to the IR Extender cable for IR signal reception.
Ensure that remote being used is within the direct line-of-sight of the IR
extender.
8
Link LED: The yellow LED will illuminate when both the input and output
signals are connected.
9
CAT5e/6 Out: Connect to the receiver unit with an single CAT5e/6/7
cable for transmission of all data signals.
3 3
RS-232 In
RS-232 In
Transmitter
Transmitter
HDMI to CAT5e/6 with LAN/IR/RS232
HDMI to CAT5e/6 with LAN/IR/RS232
3
3
Rear
Rear
4
4
5
5
6
6
7
7
8
8
9
9