CYP COH-RX1 Посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач CYP COH-RX1. CYP COH-RX1 16 сторінок. Hdmi to optical transmitter and receiver

Друкувати сторінку

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

Error

HDMI

Input

Optical

HDMI

OPTICAL LED: This blue LED will illuminate when at least one

optical cable is connected and has successfully detected and

communicated data between the Transmitter and Receiver.

Note: If the LED is not illuminated then users will need to check

the connection of the fiber cable between the Transmitter and

Receiver units and then check the connection is good and that

the cable itself is correct and undamaged.

ERROR LED: This red LED will illuminate when there is an error in the

input signal data rate that is higher than 75/170MHz (Single/Dual).

Double Check all connections and make sure they are properly

connected.

HDMI LED: This blue LED will illuminate when the Transmitter unit is

receiving a HDMI signal from the source device.

HDMI INPUT: Connect to an HDMI input source such as a DVD or

Blu-ray player with a HDMI cable.

IR-OUT: Connect to the supplied IR blaster cable for IR signal

transmission. Place the IR blaster in direct line-of-sight of the

equipment to be controlled.

RS-232: Connect to a PC or laptop (with supplied 3.5mm phone

jack to D-Sub 9pin adaptor) for the transmission of RS-232

commands.

OPTICAL SUB & MAIN: Connect the Transmitter and Receiver units

with 2-way fiber optical cable to transmit the data signal

Note: Connector Type: LC-LC, Fiber: Duplex Single-mode Fiber

DC 5V: Connect to the power adaptor included in the package

from the AC wall outlet for power supply.

IR-Out

RS-232

Optical

SUB

Main

DC 5V