CYP PU-507RX-2H Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач CYP PU-507RX-2H. CYP PU-507RX-2H 16 сторінок. 5-play hdbaset receiver with dual hdmi outputs
Друкувати сторінку
6.2 Rear Panel
POWER
1
1
POWER LED:
Once the power supply is connected the LED will illuminate.
2
DC 24V:
Plug the 24V DC power supply into the unit and connect the adaptor
to an AC outlet.
3
IR 2 BLASTER:
Connect to the supplied IR Blaster cable for IR signal transmission.
Place the IR Blaster in direct line-of-sight of the equipment to be
controlled.
4
IR 1 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception.
Ensure that remote controller being used is within the direct line-of-
sight of the IR Extender.
5
USB:
This port is reserved for firmware update only.
6
LINK:
The link LED will illuminate when CAT5e/6/7 output have been
connected to the Receiver and the Receiver have connected with
display that shows image on screen.
7
CAT5e/6 IN:
Connect this port to HDMI to CAT5e/6/7 Transmitter (with or without
PoE function) with CAT5e/6/7 cable to extend the signal up to 100m.
IR 2
BLASTER
IR 1
DC 24V
EXTENDER
2
3
4
USB
LINK
CAT5e/6 IN
5
6
7
9