CYP CH-1601TXRX Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Подовжувач CYP CH-1601TXRX. CYP CH-1601TXRX 20 сторінок. Hdmi/audio over cat5e/6/7 extender with 48v poh
Також для CYP CH-1601TXRX: Посібник з експлуатації (15 сторінок)
Друкувати сторінку
function to be activate or not. Switch to OFF to disable ARC
function.
Switch to ON allows Receiver's HDMI output/COAX IN audio to be
routed back and output to both HDMI IN and COAX OUT 1 on the
Transmitter side.
Note: When ARC switch to ON, depending on the connected
devices of the HDMI OUT & Coaxial in from Receiver and the
connected device of the HDMI In & Coaxial Out at the Transmitter
the audio format and behavior may be varied. The ARC input/
output transmission distance may be varied too, it is suggested to
use cable within 2 meters long to ensure the best audio quality.
6.3 Receiver's Front Panel
RS 232 OUT
UPDATE
1
2
1
Update Switch
Switch this deep switch to right for firmware update use, under
normal operation, leave the switch on left.
2
RS-232 OUT
Connect to the device that is to be controlled (via D-Sub 9-pin
male cable) by RS-232 commands.
IR IN1
3
Connect to the supplied IR Extender cable for IR signal reception.
Ensure that remote being used is within the direct line-of-sight of
the IR Extender.
4
IR OUT 2
Connect to the supplied IR Blaster cable for IR signal transmission.
Place the IR Blaster in direct line-of-sight of the equipment to be
controlled.
5
LAN
Connect to internet or network service system to this slot or to
5
IR IN 1 IR OUT 2
LAN
3
4
5
CAT5e/6/7 IN
POWER
6
7