Ashdown MiBass 2.0 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Ashdown MiBass 2.0. Ashdown MiBass 2.0 5 сторінок.

FRONT PANEL

LINE IN

A single balanced line input is provided for play along practice. Used in conjunction with the

Headphones socket for silent practice. Also see, MIX.

LINE MIX

Set the level of your Backing Track by using the 'MIX' Rotary control provided.

OUTPUT

Use the output level control to adjust the playing volume of the amplifier.

E.Q.

This passive EQ has bass, middle and treble tone controls.

GAIN

This adds tube emulated overdrive as a tube amp would when adding gain. From slight grit to

full on overdrive.

INPUT

A single input jack socket is Provided for your instrument. This is a high impedance input

designed to perfectly match the impedance of the pick-ups on a passive bass. It also has

sufficient headroom available to allow active basses to be used. Use the input gain control to

adjust for the sensitivity of your instrument.

Ashdown Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Ashdown 2011.

www.ashdownmusic.com

USER MANUAL

MiBass 2.0

HEADPHONES

A headphone jack socket is provided to allow stereo headphones to be plugged into the

amplifier for silent practice. This cuts out the main speaker when a jack plug is inserted.

DIRECT INJECT (D.I.)

A balanced D.I. Is provided on the rear panel XLR socket. This provides a post E.Q. Post

effects signal. The output signal from this XLR socket is set to a level and impedance suitable

for connecting directly into a balanced microphone input of a mixing desk for either direct

injection into the pa system or for recording.

FUSED MAINS INLET SOCKET

This is for connection of the unit to your countries mains power supply. Please ensure that

the type and rating of mains fuse marked on the rear panel is used when this is replaced.

ON/OFF MAINS SWITCH - Using the mains cable supplied the amplifier may be connected

the to the correct voltage mains supply , Once this is done turn the power to the MiBass 2.0

on by using the rear panel ON/OFF switch. POWER ON is indicated by illumination of the

BLUE LINE Logo on the front of the amp.

SPEAKER OUTPUT

Two SPEAKER OUTPUTS are provided on SPEAKON/JACK connection sockets that are

able to handle the high powers produced by these amplifiers.