CYP CPLUS-V4E Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Кабелі та роз'єми CYP CPLUS-V4E. CYP CPLUS-V4E 16 сторінок. 1 by 4 6g hdmi splitter
Друкувати сторінку
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER
1
1
POWER: This LED will illuminate when the device is connected to an
active power supply.
2
6G/3G: When input source bandwidth is 6G, the 6G LED will
illuminate, when input source detect as 3G, the 3G LED will
illuminate.
IN SYNC: When input detected, the LED will illuminate, the LED will
3
flicker when detected abnormal, for example, when source signal
not stabled, and when input is not connected, the LED light will off.
4
IN HDCP: When Input HDCP has been detected, the LED will
illuminate, the LED will flicker when HDCP abnormal, for example
when HDCP version is not supported, and when no HDCP
detected, the LED will off.
5
OUT 1~4 SYNC: When output detected, the LED will illuminate,
the LED will flicker when detected abnormal, for example, when
output connected but the output sense is off, and when output is
not connected, the LED will off.
6
OUT1~4 HDCP: When output HDCP working, the LED will illuminate,
the LED light flicker when HDCP abnormal, for example, when
HDCP version is not supported, and when no HDCP detected, the
LED will off.
7
EDID: Switch the dip could choose EDID mode to Standard (STD)
mode or TV mode. When on TV mode, the unit will automatically
detect and store output 1 sink EDID data, if switch to STD mode,
the unit will set to standard 1080p and PCM 2 channel.
8
SYS-RST: Switch the dip from off to on, the unit will trigger TV to it's
HDMI input1 immediately, when dip stays in on, the unit will trigger
cycle in every 8~10 minutes. (*The purpose of this function is to
3
3
5
6G
IN
OUT 1
OUT 2
OUT 3
3G
2
4
6
OUT 4
EDID
SYNC
HDCP
STD
TV
7
SYS-RST
ON
OFF
8