Cloud BT-1AFW Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Блок управління Cloud BT-1AFW. Cloud BT-1AFW 16 сторінок. Bt-i series bluetooth wireless audio module

Друкувати сторінку

Introduction

The BT-1 is a wireless remote audio input module for use with all Cloud products fitted with an RJ45 Facility Port or an RJ45

Extension Port.

The BT-1 enables compatible portable devices such as laptops, tablets and smartphones to stream audio wirelessly to the

interface, and thus into the audio system of the Zone where the interface is installed.

The BT-1 is connected to the host unit's Facility Port or Extension Port by a single Cat 5 cable. Alternatively, it may be connected

to remote Cloud input modules such as the LM-2, LE-1 and BE-1 in "daisy-chain" fashion, these modules being connected in

turn to the host unit. Screened Cat 5 cable and shielded RJ45 connectors should be used in all cases. If the Zone where the

BT-1 is installed also requires RL and RSL Series remote control plates, they may be "daisy-chained" to the BT-1 instead of being

connected to the host unit, which will simplify installation wiring in many cases.

BT-1 variants

There are two primary variants of the BT-1: the BT-1F, suitable for use with host units fitted with one or more Facility Ports, and

the BT-1E, suitable for use with host units fitted with one or more Extension Ports. The BT-1F will route an (L+R) mono sum of

the streamed audio to the host unit; the BT-1E routes the audio in stereo.

Variant BT-1F may be used with the following Cloud products, which are fitted with Facility Port(s):

•

and Z8

Zone Mixers

MK4

•

and Z8

Zone Mixers

MK3

•

46-120 and 46-120

MEDIA

•

MA40F, MA40T and MA40E Mini Amplifiers

Variant BT-1E may be used with the following Cloud products, which are fitted with Extension Port(s):

•

DCM1

Digital Control Zone Mixer

•

DCM1e

Ethernet Digital Control Zone Mixer

BT-1E and BT-1F variants may be distinguished physically by an ident on the rear PCB: a black mark will be visible in one of two

checkboxes:

•

DCM1:

BT-1E

•

FACILITY: BT-1F

Additionally, the BT-1 is available in two form factors to suit either UK single-gang or US standard dual-gang electrical back

boxes; US-size modules are denoted by a suffix 'A' to the Part No.

UK-size modules are available either in white (a further suffix 'W' to the Part No.), or black (suffix 'B') finish.

NOTE: Unless specifically stated otherwise, all references to "BT-1" in this Installation Guide can be taken to apply to all BT-1

mechanical and cosmetic variants.

Mounting - mechanical

BT -1 (UK version)

The Cloud BT-1 (BT-1FB, BT-1FW, BT-1EB, BT-1EW) fits a standard UK-style single-gang electrical back box. The box used should

have a depth of at least 35 mm.

BT -1A (US version)

The Cloud BT-1A (BT-1AFW, BT-1AEW) fits a standard US dual-gang electrical 'J' box in vertical orientation. The box used

should have a depth of at least 1½".

BT-1 Installation Guide v1.0

Zone Mixing Amplifiers