Ashly LIMITER/COMPRESSORS CL-50E Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Ashly LIMITER/COMPRESSORS CL-50E. Ashly LIMITER/COMPRESSORS CL-50E 18 сторінок. Limiter/compressors
Також для Ashly LIMITER/COMPRESSORS CL-50E: Посібник користувача (18 сторінок), Брошура та технічні характеристики (2 сторінок), Брошура та технічні характеристики (2 сторінок)

4. If you have problems, please refer to the more detailed sections and to

the troubleshooting

guide in this manual. Q

MECHANICAL INSTALLATION

The CL-50E and CL-52E Compressor/Limiters

mount in a standard 19

inch equipment rack. The mounting

screw threads vary with different rack

manufacturers and you should refer to your rack instructions for proper

hardware. An oval head or flat head screw with a plastic countersink washer

is preferred to protect the finish of the compressor/limiter under the screw.

The CL-100 is housed in an industry standard half-rack enclosure which

provides a variety of mounting options. It can be used free-standing, in a half-

rack-sized enclosure, mounted in a vertical 19 inch adaptor with up to eight

other half-rack products, or side by side with another half-rack product in a

standard 19-inch

rack. Mounting accessories

are available from Ashly to

accomplish this.

Your Ashly compressor/limiter

is housed in a rugged steel case and will

tolerate moderate abuse. However, for road systems which may be dropped

or otherwise subjected to extreme forces, we recommend some rear support

for the chassis to prevent bending the front panel when these forces occur. Q

WIRING

The CL-50E and CL-52E Compressor/Limiter

should be connected to a

3-wire grounded outlet supplying 120 Volts, 50-60 Hz. Power consumption is

12 watts. The CL-100 uses a standard RAP-6 remote AC power supply.

The INPUT is a 10k ohm active balanced type on a standard stereo

phone plug that will accept levels of up to +20 dBV. The (+) or in-phase

connection is on the tip and the (-) or out-of-phase connection is on the ring.

To use the input as a common unbalanced type, simply use a mono phone

plug in the usual way.

The OUTPUT connection

is a standard 1/4" phone jack and mates with a

standard phone plug such as a Switchcraft 280. Output impedance is 200