Cypress CHDBR-2HE Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Приймач Cypress CHDBR-2HE. Cypress CHDBR-2HE 16 сторінок. 1 by 2 cat5e/6/7 over hdmi with lan/ir/rs232/bi-directional poe receiver
Також для Cypress CHDBR-2HE: Посібник з експлуатації (16 сторінок)
Друкувати сторінку
6.2 Rear Panel
POWER
DC 24V
1
1
POWER LED:
Once the power supply is connected the LED will illuminate.
2
DC 24V:
Plug the 24V DC power supply into the unit and connect the
adaptor to an AC outlet.
3
IR 2 BLASTER:
Connect to the supplied IR Blaster cable for IR signal transmission.
Place the IR Blaster in direct line-of-sight of the equipment to be
controlled.
4
IR 1 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception.
Ensure that remote controller being used is within the direct line-of-
sight of the IR Extender.
5
USB:
This port is reserved for firmware update only.
6
LINK LED:
The link LED will illuminate when both the input source and output
display signals are connected through CAT cable. When it blinks
regularly it states the display is NOT sending signals to Receiver but
the Transmitter and Receiver are linked and if it blink irregularly it
states an error has occurred.
7
CAT5e/6/7 IN:
Connect this port to HDMI to CAT5e/6/7 Transmitter (with or without
PoE function) with CAT5e/6/7 cable to extend the signal up to
100m.
IR 2
BLASTER
IR 1
EXTENDER
2
3
4
CAT5e/6/7 IN
LINK
USB
5
6
7
4