Cypress Envirosystems WPT Series Експлуатація та технічне обслуговування - Сторінка 8
Переглянути онлайн або завантажити pdf Експлуатація та технічне обслуговування для Терморегулятор Cypress Envirosystems WPT Series. Cypress Envirosystems WPT Series 10 сторінок.
Друкувати сторінку
7.2
Product Error Codes
7.2.1
WPT
Code
Cause
Indicates that the WPT is
performing a discovery
dy
operation and it should not
be disturbed.
Indicates that the WPT is
dt
performing a diagnostic
operation.
Indicates that the WPT is
Fd
performing a forced
discovery operation.
Indicates that the buttons
UL
are unlocked by the user.
Indicates that the buttons
LC
are locked.
Discovery error – Not able
E0
to connect to nearest
repeater or HUSB
Time synchronization error
– Not able to synchronize
E1
the WPT time with the
wireless network
Radio error – Not able to
E2
send/receive data
Optical Sensor Error – Not
E4
able to properly position
motor/cam
WPT Operations and Maintenance
Document No. 910-00028-01, Rev 1
Possible Solution
This indication disappears automatically
after a few seconds.
This indication disappears automatically
after a few seconds.
This indication disappears automatically
after a few seconds.
This indication disappears automatically
after a few seconds.
This indication disappears automatically
after a few seconds.
Retry discovery by pressing any button.
Check if repeater or HUSB is working.
Try resetting the repeater.
Try with a different position of the
repeater/ HUSB if feasible.
If this error occurs after successful
commissioning of the system, the WPT
will recover from this error within a couple
of refresh cycles.
Restart the unit with removing and
inserting the battery. If the error
continues, the device requires
replacement. Contact the distributor.
This error is an indication of a defective
device. The unit should be replaced.
Page 8 of 10