Cypress Envirosystems WPT-800-DB Series Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Терморегулятор Cypress Envirosystems WPT-800-DB Series. Cypress Envirosystems WPT-800-DB Series 20 сторінок. Wpt-db series deadband wireless pneumatic thermostat
Друкувати сторінкуThermostat Lever Handling Precautions
•
Great care must be exercised while calibrating the WPT-DB.
•
Handle the thermostat lever as little as possible.
•
Use extreme caution not to allow the lever to rotate sideways while adjusting
the setscrew.
•
Damage to the bi-metallic spring can result if the end of the lever is allowed to
move left or right by more than 1/16".
2.1.2
Installing the WPT-DB
The WPT-DB is installed in the existing thermostat location using the Universal Wall
Bracket provided with the WPT-DB kit. To install the WPT-DB:
1. Remove the plastic cover of the WPT-DB using a 1/16" Allen wrench on the
bottom screw.
2. If the Universal Wall-mounting Bracket is attached to WPT-DB, remove it by
unscrewing the two captive screws on the bottom of the WPT-DB, as shown in
Figure 3.
WPT-DB Installation Manual
Document No. 910-00014-01, Rev. 04
Figure 2. WPT-DB Lever
Calibration
Screw
Do Not Touch
Page 3 of 20