Cyrus 7 Інструкція користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція користувача для Підсилювач Cyrus 7. Cyrus 7 6 сторінок.
Друкувати сторінку
Cyrus 7
TROUBLESHOOTING GUIDE
If your Cyrus 7 is not operating properly, disconnect the power and check
carefully all connections.
If you are in any doubt, consult your dealer.
No sound
Amplifier switched off or in Standby
Mute is on (RED light on Vol. Ring)
Tape Monitor on (RED tape light)
Source not working
(e.g. CD not playing)
No sound from one loudspeaker
BAL control at extreme limit
Does your speaker have fuses?
Speaker cables / interconnects faulty
Spurious noises from speakers
Interconnects or connections faulty
No response from any keys
Switch off at rear panel, wait one minute and switch on.
The problem should clear
The Cyrus 7 has a unique fault indication system to help you to diagnose
problems. All fault indications appear on the Standby light on the front panel.
Fault indications at first installation of a Cyrus 7 with a PSX-R
Flashing Green
The Cyrus 7 is modified for
PSX-R but the PSX-R is not properly
connected
A PSX-R is connected to a Cyrus 7
which has not been modified to take
the PSX-R
Fault Indications during use
Flashing Green and Yellow
An overload condition usually
caused by excessive level or a
problem with your loudspeakers
Flashing Green
A fault condition has been reported
from the PSX-R
Flashing Red
An internal problem with Cyrus 7 or
PSX-R
Remote control not working
Remote control not operating
Remote control will not operate a
Cyrus CD player or tuner
If a fault condition still remains, return the Cyrus 7 (together with the PSX-R if
you are using one) to your Cyrus appointed dealer or an authorised Service
Centre.
4
Bring unit out of Standby
(Standby light - GREEN)
Deselect Mute
De-select Tape 2
See 'Fault Indication System'
Centralise Balance
Check speaker, replace fuses
Check connections, cables -
replace if needed
Check, replace where necessary
Check PSX-R is plugged into Cyrus
7 and that both units are connected
to the mains
Unplug PSX-R, check Cyrus 7. If
Cyrus 7 works OK, return to dealer
for modification
Reduce level or Unplug speakers
amplifier should restore
Switch off power to both units, wait
one minute, switch on - amplifier
should restore
Switch off and on - amplifier should
restore
Check batteries
CD or TU button must be pressed
before sending a command
WARRANTY
The warranty card enclosed should be completed by the Dealer and the
purchaser and returned to CYRUS or its Distributor within 8 days of
purchase. No Dealer or Distributor may vary the terms of this warranty,
which is personal to the original Purchaser and is not transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer
from whom the equipment was purchased.
This warranty excludes:
•
Damage caused through neglect, accident, misuse, wear and tear,
or through incorrect installation, adjustment or repair by
unauthorised personnel. Any unauthorised servicing will result in
loss of warranty.
•
Liability for damage or loss occurring in transit to or from the
purchaser.
•
Consequential damage, loss or injury, arising from or in conjunction
with this equipment.
Equipment for attention under warranty should be consigned return
carriage paid. If returned equipment is found to comply with the
published specification, CYRUS reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a
SPECIFICATIONS
Power Supply
Voltage: .......................................................................... As plate on rear of unit
Power Consumption
Standby ..................................................................................................... (12W)
ON (No Load) ............................................................................................ (23W)
ON (2 x 50W/Ch)..................................................................................... (185W)
EMC & Safety Compliance.............................................................................CE
Enclosure
Dimensions (WxHxD)............................................................ 215 x 75 x 365mm
Weight ....................................................................................................... 4.6Kg
Material......................................................................................Die cast chassis
Audio Performance
Input Sensitivity (50W/8Ω).............................. Line................................ 200mV
Input Impedance ............................................. Line.................................100kΩ
Frequency Response (-3dB) ........................... Line......................... 4Hz, 90kHz
Signal to Noise Ratio (A-WTD) ....................... Line............................... 102dBA
Power Output (both channels driven).............. 8 Ohms .............................. 60W
THD+N (Pre-Amp) 1kHz ................................. Line............................. <0.002%
THD+N (1kHz, 2/3 power)............................... 8 Ohms ....................... <0.003%
(both channels driven)
Cyrus reserves the right to change all specifications without notice. E &OE
User Instructions
consumer.
GB
GB