Cyrus Mono X 200 Signature Інструкція користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція користувача для Підсилювач Cyrus Mono X 200 Signature. Cyrus Mono X 200 Signature 12 сторінок. Power amplifier
Друкувати сторінку
Cyrus Mono X 200 Signature & Mono X 300 Signature
Power Control
When power is first applied, the amplifier will initialise, then set to
Standby.
Power control from the front panel
Press the STANDBY key a briefly to switch the amplifier between
operational and standby modes. The Standby Indicator b will glow green
when operational or red when set to Standby.
Music sensing automatic power control
Music sense power control can be enabled if required.
To enable or disable Music sense, first set the amplifier to Standby, then
press and hold the STANDBY key for two seconds. The Standby Indicator
will flash red three times, then change colour to show the status of Music
sense – orange when enabled or red when disabled.
When Music sense is enabled, the amplifier will switch on automatically if
a music signal is detected from the pre-amplifier, and set to Standby after
10 minutes of silence. The STANDBY key may also be used to switch the
amplifier on if required, or to switch the amplifier back to Standby with
Music sense enabled (Standby indicator will glow orange).
NOTE: Standby power consumption will be significantly higher when
Music sense is enabled.
A 12V trigger, MC-BUS or RS232 'OFF' command cancels the Music
sense function.
a
b
c
INPUT
d
Key to the front panel drawing
1.
Standby key
2.
Standby indicator
3.
Input indicator
4.
Input selector key
OPERATION
Zero Feedback
Input Indicator
The INPUT Indicator c will glow red when the output of the Mono X
Signature is muted. This occurs for a few seconds following Standby
operation or if a temporary overload condition arises. If the INPUT Indicator
flashes at any time, refer to the Troubleshooting Guide.
Selecting an Input
The front panel INPUT key d selects RCA Phono or Balanced input
connection. To change inputs, the amplifier must be switched on.
Press and hold the INPUT key d until the INPUT indicator c changes
colour as shown.
INPuT Indicator colour
Green
Orange
NOTE: The input setting will be retained when mains power is
disconnected.
6
User Instructions
300
Mono X
Input selected
Balanced
RCA Phono