Cytech Comfort Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Домофонна система Cytech Comfort. Cytech Comfort 16 сторінок. Door station

Increase the value in Location 118 to 250 (maximum 255) to start with, reset the Comfort PCB

and test. If necessary, reduce the value in Location 118 to lower the voume of telephone voice on

the Door Station. Always do a dial test after changing these locations to confirm that dialout

is not affected.

Door Station Programming

Location 1674 determines how many Door Stations are installed in the system. Enter valid values

0 or 1 and reset the system by pressing the Reset button on the Comfort PCB. When the Door

Station button is pressed, a chime is heard on the Door Station and keypads. In Home, Night and

Day Modes, the phones on the premises will ring if a Ringer Module is installed. In Away (and

Vacation) mode the system will dial to the programmed number according to the settings in Alarm

Type 25. A Doorbell Response may be programmed in Location 1691, which may be used for

switching cameras or other supplementary actions.

Door Station as Internal Intercom

The Door Station can be used as an intercom within the premises, by making it appear as a

Keypad. Set JP5 so that the Door Station is a Keypad. Set the ID switches in SW1 to select the

next available address for a Keypad. Program Location 1675 to correspond to the number of

Keypads in the system. Reset the Comfort panel. Pressing the Doorbell button will initiate the

Intercom mode just like pressing the F + 8 function key. The Doorbell button also switches

communications to talk mode when communications is established. However, this intercom

cannot terminate the Intercom Mode, as there is no F key. Intercom mode can be terminated by

the other Keypad or can be left to 'time out'. .

After completion, disable Comfort's RS485 data port KA-KB by setting Location 1672 to '0'

by entering Engineer Menu 7,4,1, then RESET. Comfort is always ready to receive data if

this flag is set, making the system vulnerable through the Doorphone.

In Security Off, press the Doorbell button. The Keypads will produce a door chime. If a ringer

board is connected, the house telephones will ring. Press any button on one of the Keypads. The

Keypad says

Press 0 for Door Station

Press 0. You can now talk to the Door Station. In this mode, only one side can talk at any time,

while the other side listens. The red MIC led on the Keypad and Door Station comes on when the

respective station is in Talk Mode. The Keypad controls the direction of the conversation by

pressing 1 to switch from talk to listen and vice versa. To end, press the F key. You can see the

red MIC led through the semi-translucent polycarbonate housing.

Press the Doorbell button again, but this time, use the local telephone to answer the chime. As

before, press 0 for Door Station. With the telephone, you can talk naturally with the Door Station

without having to press 1. Just hang up to end the conversation. Obviously, using the phone to

talk to the Door Station is preferable to the Keypad, but the Keypad may be closer than the

nearest telephone sometimes.

In Security Off, Day and Night modes, when people are at home, you can use the local phone or

Keypad to answer the Door Station

If more than 1 Door Station is installed, pressing 0 for Door Station will connect to the one where

the doorbell button was pressed. Pressing 1 to 3 will select the Door Station number directly.