BlueParrott C300-XT Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Гарнітури BlueParrott C300-XT. BlueParrott C300-XT 20 сторінок.
Також для BlueParrott C300-XT: Початок роботи (13 сторінок), Початок роботи (13 сторінок)
Друкувати сторінку
ADVANCED FEATURES AND FUNCTIONS
Multiple Device Pairing and Multipoint Mode
The C300-XT has pairing memory for up to eight (8) devices . The headset can also use
Multipoint Mode, which means that it can be connected to two (2) Bluetooth devices
at the same time . You do not have to do anything to enable Multipoint Mode .
Using the C300-XT in Multipoint Mode
1 . First make sure the headset is paired with both your devices .
2 . With both devices in range and with their Bluetooth enabled, turn the headset on .
3 . As each Bluetooth device connects to the headset, you will hear the voice prompt,
"Your headset is connected . "
The C300-XT will monitor both phones and enable you to answer a call on either one
using the headset .
If you are on a call and the other device receives a call, you will hear a notification in
the headset .
Disabling and Re-enabling Multipoint Mode
Multipoint Mode can be disabled with the following process:
1 . "Unpair" (Android) or "forget" (iOS) the C300-XT from your phone's Bluetooth list .
2 . Power on the headset .
3 . Press and hold the Parrott Button, MFB and Volume Up buttons at the same time
for 6-7 seconds . The MFB LED will flash blue twice, and the headset will enter
Pairing Mode .
4 . Re-pair the C300-XT to your device .
5 . Multipoint Mode is disabled and the headset can only be used with one device at a
time .
If you wish to re-enable Multipoint Mode, repeat the process above .
Proximity Pairing
Proximity Pairing is an alternative method of pairing where the headset initiates the
pairing process instead of your phone .
1 . Make sure the headset is powered on and not connected to another device .
2 . Set your phone so it is "discoverable," or visible to other devices .
3 . Simultaneously press the MFB and the Volume Down button, if headset is not
already in pair mode .
4 . You should hear the voice prompt "pair mode" in the headset .
5 . The headset LEDs should now be alternating red and blue .
6 . The headset initiates pairing activity, and the incoming pairing request must be
accepted on the phone . NOTE: This may include entering the pin number "0000"
(four zeros) .
BlueParrott C300-XT User Manual
PAGE 16