BlueParrott S450-XT Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Гарнітури BlueParrott S450-XT. BlueParrott S450-XT 16 сторінок.

GETTING STARTED

Regular Pairing to a Bluetooth Device

Placing the S450-XT into Pairing Mode

When you turn your S450-XT on for the first time, or if its Paired Device List has been cleared, it will go

into pairing mode automatically. If the S450-XT has already been paired with another device and you are

not going to use NFC Pairing, you will need to put it into Pairing Mode manually:

Power on the headset and then press and hold the MFB for approximately 6 seconds until you hear

the audio prompt "discovering." The headset LED will be flashing alternating red and blue.

The S450-XT will be visible for pairing to devices for 120 seconds.

Pairing to a Cell Phone

1. Make sure that other Bluetooth devices are turned off or out of range.

2. Place the S450-XT into pairing mode.

3. Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer's instructions.

4. Select "VXi S450-XT" to pair. (Passcode is "0000" if needed.)

5. When connected, the headset will give you the voice prompt, "Your headset is connected" and the

indicator light will flash blue.

Using Wired Audio

Connect the audio cable to the headset and to the 3.5 mm jack connector on your mobile device or PC.

Note: Bluetooth and USB headset functionality are disabled when using the audio cable connection.

Connect the S450-XT to a PC using the supplied micro-USB cable (the audio cable must not be

connected to the headset when using USB).

Note: It is not possible to connect to a mobile device wirelessly and to your PC via USB at the same time.

(Bluetooth functionality is disabled while there is an active USB connection.)

VXi BlueParrott

S450-XT User Guide

(continued)

PAGE 8