BluePoint Fasteners BP-27C Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Інструменти BluePoint Fasteners BP-27C. BluePoint Fasteners BP-27C 13 сторінок.
Друкувати сторінкуBP-27C OPERATING INSTRUCTIONS
BP-27C IS NOT A STAND-ALONE TOOL.
IT MUST ALWAYS BE USED MOUNTED ON A BLUE POINT POLE.
1.
After checking to make sure that the
tool is not loaded, point it in a safe
direction and insert a fastener into
the
Nosepiece of the tool until it is
fully seated. If a clip assembly is
being used, be sure it is positioned in
the cutout section of the Spall Guard.
DO NOT USE EXCESSIVE
FORCE WHILE INSERTING A
FASTENER
2.
With the tool pointing in a safe
direction and your fingers off the
Advance Lever, insert the strip load
through the bottom of the handle
and push through until your fingers
touch the handle recess. Never try
to insert a load strip into the tool
from the top of the receiver.
3.
Raise the tool upwards carefully
without bumping any other object
and gently place it on the ceiling
where you want to fasten. Hold it
perpendicular to the work surface
and push upwards to compress the
firing pin spring and release the
sear to fire the tool. If the tool
does not fire, hold the tool for 30
seconds and then follow the
misfire procedure described on
page 10.
12
4.
After one shot is fired, point it in a
safe direction and insert the next
fastener into the Nosepiece, and
then press the Advance Lever
Assembly of the
housing
to
advance the next load, and repeat
the firing operation.
5.
After all 10 shots are fired, pull the
load strip from the TOP of the tool.
NEVER
PULL
IT
FROM
THE
BOTTOM.
Please watch the videos on our website:
6.
Check the tool frequently to ensure
that the muzzle bushing and loads
strip track are clear, if you are
working at a site with dirt and
debris.
CHECK THE NOSEPIECE BUSHING
AND LOAD STRIP TRACK FOR
DEBRIS
IF YOU DECIDE NOT TO MAKE A
FASTENING AFTER THE TOOL HAS
BEEN LOADED, ALWAYS REMOVE
THE POWDER LOADS FIRST, THEN
THE FASTENER. THIS WILL PREVENT
ACCIDENTAL DISCHARGING OF THE
FASTENER OR PISTON INTO THE
OPERATION HAND.
NOTE: Use of partially used
load strips.
If you want to use a partially fired load
strip, the end of the strip containing
the live loads should be placed into
the bottom of the tool handle. Count
the number of unfired loads in the
strip before inserting it and keep a
count as the fastenings are being
made, you can easily determine when
all the loads have been used.
http://bpfasteners.com/licensing/video
13