Blueprint Subsea Navigator Посібник із швидкого запуску та довідник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого запуску та довідник для Водолазний інструмент Blueprint Subsea Navigator. Blueprint Subsea Navigator 2 сторінки.

Друкувати сторінку

PRE-DIVE CHECKLIST

With Navigator connected to a PC...

Check that any required mission files have been uploaded onto the Navigator

Check that Mission files to be used have enough free "marker" slots to allow

the diver to define any in-mission markers if required.

Check there is enough free space on the internal storage for the Dive-Log file

(allow approximately 1Mb of storage space per minute of the dive).

Hardware preparation...

Check a fully charged battery been fitted and the housing cap is tight and

sealed correctly.

Check that all cables are fitted into all connector sockets, preventing water

ingress.

Check the cable of the GPS Float is securely attached to the console frame,

avoiding strain on the connector.

Software preparation, prior to use by the diver...

Power on the Navigator and check the required status icons go green...

Check the GPS status icon on the Navigator status bar is visible and green (red

indicates no GPS connected, yellow no GPS fix currently available).

The Immersion Sensor droplet icon is red when the Navigator is not

submerged. When submerged, dive logging starts automatically (the disk icon

goes green).

If no droplet icon is shown, the immersion sensor is not enabled, so manually

start dive logging if required from the "Settings" app.

NAVIGATION

Choose a mission file from the

Use the GPS display to check the GPS is

Settings display.

working (status icon should be green).

Selected Mission

GPS Fix Good

Press "F2/Down" to cycle through

Align the status bar "bubble" on the

markers and choose a destination.

centre marks and swim towards target.

Selected

mission

marker

On the Navigation display, press

"F3/Left" to change the chart scale.

Current chart

scale

Use the Dive Profile screen to review

the progress of your dive.

Distance to

Direction to

swim

USING APPLICATIONS

Application Key Functions...

Switch Application

F1 / Up

F2 / Down

Navigation

Add Marker

Next Marker

Zero Depth

Dive Profile

Sensor

Compass

Calibrate

Set Time From

GPS

Selection

Settings

REVIEWING DIVE LOGS

To download recorded "Dive Log" data (or upload new "Mission" files)...

Plug the USB lead into the USB connector at the base of the console, and

connect the other end of the lead into a free USB socket on a PC / Laptop that

has the PinPoint software installed.

Turn Navigator on and after a few seconds the Windows™ operating system

should detect it, appearing as a "Mass Storage Device" (similar to a USB pen-

drive).

Use the Windows File Explorer (or other file manager) to download and remove

any Dive Log files (or upload new mission files).

To prevent corruption to any of the files, always follow the Windows "Safely

Remove Hardware & Eject Media" procedure, before disconnecting the USB

cable or powering-down the Navigator.

PinPoint Icons...

Dive Timer

Dive Log

Recording

F3 / Left

F4 / Right

Zoom

Display Mode

Not used

Selection

Prev Value

Next Value

Down

/ Execute

Play Log Data

Open Dive Log

Pause Playback

Export Log Data

(to other programs)

Restart Playback

Repeat Playback

Navigation Bubble...

Icons found on the Status Bar:

Target more than

90° to left/right

Target more than

60° to left/right

Target more than

30° to left/right

Target within ±30°.

Align bubble in

centre of display.

Navigation Markers...

Icons found on the Navigation App

display:

Waypoint

Target Marker

Diver Placed Marker

Pan Chart

Measure Distance/

Bearing

Zoom To Rectangle

Zoom To All Markers