REMO
REMO
REMOVING
REMO
REMO
VING
VING
VING
VING THE GU
THE GU
THE GU
THE GU
THE GUARD PLA
There are four screws that hold the guard plate in place,
two on the upper/underneath side and two on the front.
To remove the guard plate, first remove the toe kick
brackets (see page 6). Then remove the two screws on
the upper/underneath side of the guard plate. Next,
remove the two screws from the front side of the guard
plate.
Guard plate
MO
MOVING
MO
VING
VING
VING THE MA
THE MA
THE MACHINE INT
THE MA
MO
MO
VING
THE MA
1.
Position the machine in front of the cabinet
opening.
2.
Make the height adjustment while the dishwasher
is in front of the opening.
3.
Pull out the drain hose to ensure there are no sharp
bends.
4.
On the bottom rear of the dishwasher there is a
black ziptie around the rubber buffer that holds the
circulation pump in place. Cut the ziptie and remove
it.
5.
Start to feed water, electric, and drain lines into
position.
6.
Make sure you've put the protective slides on the
rear legs to prevent damaging the floor when you
slide the unit into place (see page 6).
7.
Gently slide the unit into the dishwasher opening.
As you do this, feed the drain line into the drain line
hole. Also, feed the electrical and water lines to the
CONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLE
WARNING! Before starting this procedure, be sure
1.
Connect supply cable with
a UL-listed strain relief
bushing (if nonmetallic
cable is to be used).
2.
Connect branch circuit
white lead to white lead on
main terminal block.
ARD PLA
ARD PLATE
ARD PLA
ARD PLA
TE
TE
TE
TE
After the screws are removed, grip the bottom of the
guard plate and pull it toward you to remove it. You can
now access the inlet valve, electrical connection, and
drain pump and hose, as illustrated below.
Remove the two
screws on each
side of the guard
plate.
CHINE INT
CHINE INT
CHINE INTO PLA
O PLACE
O PLA
O PLA
CHINE INT
O PLA
As you slide the unit into place, feed the drain line into
the drain line hole and the electrical and water lines to
the right front of the dishwasher.
3.
4.
CE
CE
CE
CE
WARNING! Be careful of sharp edges.
Connect branch circuit black lead to brown lead on
main terminal block.
Connect ground wire to ground on terminal block.
Remove the two
screws on each
side of the guard
plate.
Page 7
Друкувати сторінку