Egardia Bell box Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Система безпеки Egardia Bell box. Egardia Bell box 7 сторінок.

Друкувати сторінку
Please note! Set DIP switch
"
"
number 1 back to
OFF
after the bell box has been
successfully registered. The
bell box returns to normal
operation.
INSTALLING THE BELL BOX
The installation process of the Egardia bell box consists of four easy steps.
Please note! Before registering the bell box with your alarm system at least one other Egardia
accessory (e.g. a door/window sensor or a motion detector) has to be registered.
STEP 1.
CHECK CONTENTS
STEP 2.
ADD TO ALARM SYSTEM
STEP 3.
MOUNT BELL BOX
STEP 4.
CHECK AND TEST
STEP 1: CHECK CONTENTS
Check the contents of the packaging for the following parts:
1.
Bell box (batteries are factory installed in the bell box)
2.
Bag containing screws and plugs
STEP 2: ADD TO ALARM SYSTEM
You are now about to register the bell box with your Egardia alarm system.
1.
Ensure at your gateway that the alarm is turned off. The top indicator light (Status) and the
bottom indicator light (Online) are lit green.
2.
Place the bell box on a flat surface. Remove the safety screw at the bottom of the bell box and
remove the cover.
3.
Press the "Reset" button at the side of the gateway for at least 5 seconds. The top indicator
light (Status) of your gateway flashes green to indicate it is searching for new accessories.
4.
Switch the battery switch of the bell box to "ON" to activate the batteries. All LED indicators of
the bell box will glow and a beep will sound.
5.
Set DIP switch number 1 to "ON". LED 1 and LED 3 glow shortly and a short beep sounds.
After 3 seconds all LED indicators of the bell box flash once. The gateway beeps once to
indicate the bell box is successfully registered. To confirm LED 1 and LED 3 of the bell box will
flash once and a short beep sounds. The gateway beeps twice to indicate the bell box has
already been successfully registered.
6.
Set DIP switch number 1 to "OFF". LED 2 of the bell box flashes once and a beep sounds to
confirm the bell box has now returned to normal operation.
7.
Press again the "Reset" button at the side of the gateway for at least 5 seconds if no more
accessories are being added. The gateway returns to normal operation.
8.
Login to your Egardia account and go to the tab "Alarm system". The registered bell box will
appear after a few minutes.
9.
Rename the bell box for easy recognition.
10. Switch the battery switch of the bell box to "OFF" to temporarily deactivate the tamper switch.
11. Set the other DIP switches of the bell box as desired.
12. Do not replace the cover of the bell box yet.
2
CHECK THE CONTENTS OF THE BOX
REGISTER THE BELL BOX WITH YOUR
EGARDIA ALARM SYSTEM
DETERMINE THE LOCATION AND
MOUNT THE BELL BOX
CHECK AND TEST THE BELL BOX