amberroot 0B2 Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Зарядний пристрій amberroot 0B2. amberroot 0B2 17 сторінок. Solar mppt charger for upgrading inverters
Друкувати сторінку
1 Introduction
REhub enables adding Solar PV to existing backup solutions without the expense of
replacing the UPS/Inverter and batteries. REhub controls the charging of the batteries
from two sources – the Grid (charging by the existing UPS/Inverter) and the installed Solar
PV.
Adding Solar PV is the logical way to extend the backup hours and reducing the
dependence on Grid Power - but must be done the right way. REhub provides the right
combination for adding Solar PV. REhub intelligently controls the charging process in a
way that keeps the batteries safe and therefore extends their life. They allow the
maximal use of Solar power. The unit is based on a high efficiency MPPT (Maximum
Power Point Tracking) charge controller that maximizes the extraction of energy from
the PV panel.
2 General information
2.1 About this User Manual
This manual contains all the necessary information and procedures to install, configure,
use and troubleshoot REhub Solar MPPT chargers for use with Inverters. It does not contain
information about Photovoltaic modules (PV) or Batteries or Inverters of various brands
that can be connected. For information of those devices, please refer to the instructions
of each specific manufacturer.
2.2 Important safety information
This manual contains important safety instructions. Read carefully the safety and operation
instructions before using REhub. Take into consideration all the warnings mentioned both
on the equipment & in this manual. Please follow all the instructions regarding the
operation and use.
This user manual is intended to serve as a guideline for the safe and efficient use of REhub.
This manual does not contain any information meant for persons other than the personnel
qualified for the installation of such a product.
The installation and commissioning of REhub must be entrusted to qualified personnel.
The installation and use must comply with the local safety instructions and standards in
force.
2.3 Symbols used in this manual
Table 1
This symbol is used to indicate safety instructions which, if not followed, could
result in serious personal injury or death to the operator or the user.
This symbol is used to indicate a risk of material damage and/or the cancellation
of the Warranty.
2.4 WARRANTY: PRESERVE THIS DOCUMENT FOR ANY WARRANTY
CLAIMS
The warranty for this equipment depends upon the strictly following the instructions in this
manual. This Manual Contains The Warranty Period And Terms In The Last Page. PLEASE PRESERVE
THIS DOCUMENT.
3
Ver 7.0
User Manual