Blueshape CGTR2P Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Зарядний пристрій Blueshape CGTR2P. Blueshape CGTR2P 16 сторінок. Intelligent battery charger for 3-stud lithium ion batteries only
Друкувати сторінкуBattery LED indications
#
LED
1
AC
Bat #1
2
Bat #2
Bat #1
3
Bat #2
Bat #1
4
or
Bat #2
Bat #1
5
Bat #2
Bat #1
6
Bat #2
Bat #1
7
Bat #2
Bat #1
8
Bat #2
AC
9
Bat #1
Bat #2
10
INDICATION
Steady Red
There is no AC present
Steady Green
There is AC present
Steady Green
Battery is full
AC is not present and the blinking channel is ready to
Flashing Green
power or is actually powering the load on the AUX port
The battery is in charge and is charging at less than
1000mA.
Two possible conditions:
1.
Flashing Orange
2.
Steady Orange
Battery is in constant current (CC) phase
Flashing
Battery is in constant voltage (CV) and has just reached
Orange-Green
the ~90% of capacity, and is completing the charge
Premature charge termination - the battery stopped
before it was supposed to. This may be due to the
Flashing Red
battery not enabled to charge for a temporary condition.
The charger will keep retrying every 30 seconds for
approximately 2 hours.
Battery failure: several causes.
The battery should have charged but did not after 2
hours of retrying because of an internal failure.
Steady Red
The battery ID resistor is incorrect and not recognised.
(applicable range is 10K<ID<60K)
All the 3 LEDs flashing together.
Operation halted because charger has overheated. The
Flashing Red
charger will automatically resume operation when it
cools down.
EXPLANATION
The battery is in pre-charge mode because of low
voltage, and is limiting the charging current
The load connected to AUX is absorbing current
available and therefore there is not enough power
to charge the battery at full rate. The available
power is shared between charging and AUX
power and the charging current is reduced.