d&b audiotechnik Z5160 Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Адаптер d&b audiotechnik Z5160. d&b audiotechnik Z5160 6 сторінок. Load adapter

Друкувати сторінку

Fig. 1: Z5160 Load adapter

Fig. 2: Z5160 bottom row of holes and

vernier scale

Z5159

Z5160

FLYING FRAME

FRONT

INSERT

SECOND PIN

BEFORE LIFTING

Fig. 3: Z5160 Vernier scale for 2t Shackle

Z5160 Mounting instructions

Z5160 Load adapter

Table of content

1. Product description...............................................................................................3

2. Safety instructions.................................................................................................4

3. Load safety information.....................................................................................4

4. Part list Z5160 Load adapter............................................................................4

5. Weight Z5160 Load adapter............................................................................4

6. Assembly.................................................................................................................5

7. Maintenance and care........................................................................................6

8. Rigging example...................................................................................................6

The Z5160 Load adapter is intended for the use together with Z5159

Flying frame for arrays of Q loudspeakers to be suspended from a

single flying point.

The load adapter is supplied with one 2t Shackle and two locking pins,

12 mm (B2212) which are fixed to the adapter with a steel wire. The 2t

Shackle also allows the the Z5155 Hoist connector chain to be applied.

A second hole (∅: 11 mm/0.4") opposite to the 2t shackle is supplied to

accept the Z5147 Rota Clamp.

The bottom row of holes (∅: 12.5 mm/0.5") is splitted into two groups of

four holes building a "quad vernier" along with the respective hole

above the hole labeled as "1/1" (see (Fig. 2).

The Load adapter therefore allows a "quad hole value" between the

holes grid of the bars of the flying frame.

Depending on the chosen lifting device - 2t shackle or Rota clamp - the

matching vernier scale is printed on both sides of the load adapter (see

Fig. 3/4)

SELECT

LIFTING POSITION

AND INSERT PIN

Fig. 4: Z5160 Vernier scale for Rota Clamp

(1.0E)

6.1. Quick lock mechanism of the locking pins............................................5

6.2. Fitting to the Z5159 Flying frame and adjustment.............................5

7.1. Test recommendations...............................................................................6

Product description