Ambiance Flame QC888-R Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електричний обігрівач Ambiance Flame QC888-R. Ambiance Flame QC888-R 6 сторінок. Electric stove heater
Друкувати сторінку
After completely reading instructions, confirm
that all controls on stove are in the off position.
Plug the unit into a 15 amp, 120 volt outlet.
OPERATION
Controls and switches are located on front
panel inside the glass door.
FlAME: Press this button into the I position
for main power and flame effect. The indicator
light will turn on. See below for other control
switches.
hEATINg: For low heat function - Press this
switch while the FlAME switch is in the I
position for low heat. The indicator light will
turn on.
TURbO: For high heat function - Press
this switch while the FlAME and hEATINg
switches are in the I position for high heat. The
indicator light will turn on.
ThERMOSTAT: To adjust the temperature to
your individual requirements. Turn the thermo-
stat dial to the right (clockwise) to increase the
desired temperature and to the left for lower
temperature. This thermostat control dial can
only be used while the FlAME switch and
hEATINg/TURbO switches are in the I position.
FlAME INTENSITY: Turn the dimmer dial
clockwise or counter clockwise to get the
desired flame intensity. The dimmer switch
can only be used when the FlAME switch is in
the I position.
O P E R A T I O N
NOTE: When the FlAME switch is turned in O
position, all other heater functions will stop
even though the switches may be in the I
position.
ThERMOSTAT CONTROl
The heat output is controlled by the thermostat,
according to the room temperature. Set the
thermostat dial fully clockwise to the maxi-
mum position initially.
When the room is warm enough, reduce the
setting by slowly turning the thermostat dial
anticlockwise until the heater just clicks off.
This will then maintain the room temperature
at the desired level.
CAUTION
If you use this heater in conjunction with a
thermal control, a programme controller, a
timer or any other device that switches on the
heater automatically, remember to observe all
safety warnings at all times.
The stove heater has a safety overheat protec-
tion. If the overheat protection trips, turn off the
FlAME switch and unplug the power cord from
the receptacle. It should reset automatically
after 5 minutes.
4