Ambient Technologies WMTD Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Пульт дистанційного керування Ambient Technologies WMTD. Ambient Technologies WMTD 10 сторінок. Wireless wall on/off/timer remote control

Друкувати сторінку
Setting Clock:
1.
In clock setting mode, only clock and degree is displayed. Press _ to advance item (hour, minute or
temperature units (F or C)). Selected item is flashing. Press _ to select. After setting the time, press _ to
enter manual mode.
Manual Mode:
1.
Transmitter comes preset for manual
on/off operation.
2.
Press the _ button once to turn on the
appliance. Press the _ button to turn it off.
Timer mode:
1.
To select timer mode, remove the housing to access the slide switch.
2.
Select timer mode by set the slide switch to position T1 or T2.
3.
For T1, default value is 30 min. press _ key to increase the
setting to 60 or 90 min, or press _ key to decrease the setting as
desire.
4.
For T2, default value is 60 min. press _ key to increase the
setting to 120 or 180 min, or press _ key to decrease the setting
as desire.
5.
ON signal will transmit after 5 seconds of if key is pressed or 5
seconds after last key was released.
6.
OFF signal will transmit when time is up or when setting of slide
switch is changed from timer to manual mode.
Low-battery detection:
1.
Battery voltage is checked once a minute. When the
battery voltage drops to a certain level, the low-battery
warning will come on, and the transmitter will turn
off the appliance. The transmitter's keypad will not
function until fresh batteries are installed.
2.
When the batteries are low, the LCD shows a low
battery indicator. The low battery warning will be
displayed in any mode.
3.
The transmitter will not operate with low batteries.
Change the battery before the battery is too weak for
normal operation. TURN THE UNIT OFF
BEFORE REPLACING BATTERIES.
Child-proof protection:
1.
Press and hold _ and _ buttons simultaneously for 3
seconds to enter child-proof mode.
2.
The transmitter will not work mode until child-proof
mode is deactivated by pressing the _ and _ buttons
simultaneously for 3 seconds again to exit child-proof
mode.
50D0089 Rev 2
MANUAL ON/OFF
TIMER 30/60/90
TIMER 60/120/180
Child Proof
Indicator
Page 7 of 10
Slide Switch
M
T1
T2
Ambient Technologies
A Division Of MHS
Low Battery
Indicator