Ambiente 3 Tier Classic Stone Fountain Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Відкритий фонтан Ambiente 3 Tier Classic Stone Fountain. Ambiente 3 Tier Classic Stone Fountain 2 сторінки.
Installation Instruction
Forward
We recommend that you seek advice
from a builder and electrician before
you start to assemble this feature.
Whether you have purchased the 2 tier
or 3 tier the principle is the same.
Step 1
Depending on the state of the ground a
foundation may need to be constructed
to support the weight of the feature.
Step 2
The base must be level. We have
supplied you with wedges to help with
levelling your feature.
Step 3
The tubing does not need to be right
through the head. Push it in as far as
you can and seal it in with a water proof
sealant.
Feed the tubing though a bung and
the smallest bowl, then feed the tubing
through the first pedestal.
Repeat this until you have fed the
tubing through all your tiers.
Step 4
There are access panels in the middle
and upper pedestals to help feed the
tubing through.
Step 5
Feed the pump cable through the
bowl(s) and pedestal(s). Feeding it
until it goes through to the ground
and under the base.
Step 6
You should now seal all rubber
bungs with a water proof sealant.
Step 7
Fill all the bowls with clean water and
ensure pump is fully submerged.
Step 8
Plug* in, wait until trapped air has
worked its way out of the pump.
As this pump is water
cooled, allowing it to
run dry may result
in the pump burning
out, invalidating the
warranty.
DO NOT allow the pump to run dry!
Maintenance
In very low temperatures, empty, dry and
cover the fountain.
In very hot weather frequently fill the bowls
up with water. This will stop parts from
drying out to much.
Cleaning: Use a mild detergent and a soft
cloth/brush. Never clean with ammonia,
bleach or abrasives. This may damage the
finish of the feature.
Classical Stone Fountain
Standard Version
(3)
Bungs
(7)
(5)
Ground Level
Wedges
(2)
Foundation
(1)
Fountain base ring
2 & 3 Tier
Pond version
See pond version diagram for an
alternative option.
Ground Level
Place a pond liner on top of the
ground surface. When joining
Wedges
the surround together silicone
or cement it together to avoid
Pump
Foundation
access
leakage.
(4)
The tubing should be fed through
Fountain base ring
base instead of the cable.
Pond Version
Pond Liner
Water Level
Ground Level
(8)
Motar joints
Drill hole
allows pipe to
come through
*Plugs not always supplied with feature
Ground Leve
Motar join
Drill hole
allows pip
come thro
Ground Level