ACR Electronics OLAS CORE Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Система безпеки ACR Electronics OLAS CORE. ACR Electronics OLAS CORE 12 сторінок. Testing the alarm
Також для ACR Electronics OLAS CORE: Тестування точності (2 сторінок), Налаштування та перевірка дальності дії (4 сторінок), Усунення несправностей (2 сторінок), Посібник (2 сторінок), Налаштування та перевірка дальності дії (4 сторінок)

OLAS TRANSMITTERS

The OLAS TAG or the OLAS FLOAT-ON are considered OLAS transmitters. They emit a Bluetooth signal which

is monitored by the OLAS receivers.

OLAS RECEIVERS

The OLAS receivers track the OLAS transmitters. OLAS receivers are:

1. OLAS Mobile application

2. CORE - Base station for OLAS Transmitters and man overboard (MOB) alarm system

3. GUARDIAN - Wireless engine kill switch and man overboard (MOB) alarm system

4. EXTENDER - This operates as a repeater to increase the range of the CORE and GUARDIAN

OLAS MOBILE APPLICATION

The OLAS mobile application allows the OLAS transmitters to be used as a MOB/proximity alarm if connected

solely with OLAS transmitters. When an OLAS transmitter goes out of range an alarm is set off and overboard

screens are activated.

When the OLAS mobile application is connected to the Core or Guardian, it allows greater control over the OLAS

transmitters that are being tracked.

To download the app, enter "ACR OLAS" in the Apple App Store or Google Play.

IMPORTANT INFORMATION

The Core has been designed for recreational marine use. The design conforms to appropriate Electromagnetic

Compatibility (EMC) regulations but for optimal performance correct installation is required. For optimum

performance the mobile device and the Core should be located at least 0.5 meters from any equipment

transmitting, or cables carrying radio signals including VHF Radios, antennas and cables.

QUICK START GUIDE

1. Turn on OLAS transmitters within 2 meters of the CORE (press button on the OLAS Float-On for 4 secs

until it flashes green or press button on OLAS TAG for 3 secs. until it flashes green)

2. Turn on power to the Core or press the control switch once if power has already been connected

3. Wait for 30 seconds – observe the number of sound and light signals emitted by the Core. These

signals represent the number of OLAS transmitters switched on within 2 meters

4. Download the OLAS mobile application (enter "ACR OLAS" in the Apple App Store or Google Play) and

check battery status of all OLAS tags

5. WARNING: Always check the battery of any OLAS transmitter before leaving the dock. If a transmitter

battery runs out whilst being used in the system it will cause the alarm to sound

6. CHECK BEFORE FIRST USE - Place the OLAS transmitter at least 4 inches into open water (a cup or

bucket will not be enough!)

7. The alarm will sound

8. Press the control switch once to Pause the alarm

9. Bring the OLAS transmitter back within 2 meters and press the Core's switch once to reconnect

10. The Core can be switched off at any point by pressing the switch for 4 seconds or when the power is

disconnected.