AMBION FLAME EF-1510 BGL series Посібник з монтажу та інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу та інструкція з експлуатації для Внутрішній камін AMBION FLAME EF-1510 BGL series. AMBION FLAME EF-1510 BGL series 6 сторінок. Electric fireplace with remote control

Друкувати сторінку
j)
Hold the bracket in position and fix it with screws.
k) Attach the fixing angle to the bottom of the appliance using the short screws.
l)
Carefully lift the appliance and hook it to the wall bracket (Fig. 2, circle). Do not let the
appliance go until you are sure it is safely engaged to the bracket.
m) Now mark the hole position for fixing the angle, see Fig. 3. Carefully remove the appliance
from the bracket and drill holes with a depth of 1" using an 8 mm drill bit.
n) Clean the holes from dust and insert one plug in each hole. Make sure the edge is flush with the
surface.
o) Then lift up the appliance again, engage it to the bracket and finally fix the angle with screws.

Placing pebbles

The steps are only for the models with pebbles:
a) Bring down the front-panel (fig. 4)
b) Take pebbles out from package and put on the plastic board even (fig. 5)
c) Put front-panel up (fig. 6)

Instructions for Use

The appliance can be operated either by the switches are located on the top right hand side of the
fire or by supplied remote control.
Manual Operation
a) The switches are located at the top right hand side of the fire .The standby switch must be first
switch on.
b) Press once the
appear to indicate that the function is ON. Press the
dimmer mode.
c) Press once the 750W button for the low heat setting: press twice to switch off the heat setting.
d) Press once the 1500W button for the high heat setting: press twice to switch off the heat
setting.
Remote Operation
a) The standby switch located at the top right hand side of the fire must be first switch on.
b) It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons
more than once within two seconds for correct operation.
c) Press once the button on the remote control this turns the appliance and fire effect.
d) Press once the 750W button for the low heat settings: press twice to switch off the heat setting.
e) Press once the 1500W button for the high heat settings: press twice to switch off the heat
setting.
f)
Press the DIMMER button for operate the dimmer mode.

Safety Cut-Off

This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. due to
blocked air vents). For safety reasons, the fire will NOT automatically reset.
button to turn on the appliance and fire effect.. A red indicator light will
button for 3 seconds this will operate the