Ambirad Apollo QH 45-1 Інструкція з експлуатації - Сторінка 16
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Обігрівач Ambirad Apollo QH 45-1. Ambirad Apollo QH 45-1 20 сторінок. Quartz glow instant infra-red heaters
Друкувати сторінку
4.3 Sorrento Range:
1. Ensure the heater and lamp are cool and the
power supply is disconnected by removing the
plugs from the socket outlet - both plugs must
be removed even if only one lamp is to be
replaced.
2. Remove the screws from the terminal box at
the back of the lamp you wish to replace and lift
off the lid - see below.
3. Disconnect the lamp from the connector
blocks by unscrewing the screws highlighted
above below and remove the white coloured
lamp wires from the terminal block.
4. At the back of the heater, remove the plate
holding the terminal box by removing the two
fixing screws as shown below.
5. Pull the lamp wires one at a time through the
plate to remove as shown below.
6. At the front of the heater, the guard in front of
the lamp you are replacing should be removed
by gently pulling it away from the heater so it
prises out of its locating holes at each end.
7.
Remove
the
screw from the side
reflector and lift it up
away
from
the
heater to remove it.
8. Remove the
screws from both
sides
of
the
middle
reflector
and lift it up to
remove it.
9. The lamp can be
released from the
middle lamp holder
by prising back the
spring
clip
and
lifting up enough to
clear the released
clip as shown.
10. At the opposite end of the lamp the wire
should be pulled out of the side slot and the
lamp can be
lifted
up
completely
The
wires
should
be
gently pulled
so they come
out
from
behind
the
reflector.