Ambirad Apollo QH 45-3 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Обігрівач Ambirad Apollo QH 45-3. Ambirad Apollo QH 45-3 20 сторінок. Quartz glow instant infra-red heaters
Друкувати сторінку
1. Fix the heater assembly to the chains via the
hole in the centre of the joining bar as shown
below and ensure the heater faces directly
down when hanging.
Wall mounting three SOR 15's ONLY
1. Securely fasten the L-shaped wall brackets
to the mounting surface using both of the
fixing holes in the short part of the bracket.
Refer to Table 1 for recommended positioning
of the heater. Please note. wall fixings are
not supplied. They should be selected to
substantially support the weight of the
installation.
If
professional for advice!
2. Fix the heater assembly to the brackets via
the bolt threads on the middle heater. A
serrated washer should be placed on the
threads first and the wall brackets should
prise apart in order to fit the threads in place.
3. Place a washer and a nut on the thread on
the outside of the wall brackets – both sides.
4. Fit the heater assembly to the brackets and
place a washer and nut on the bolts
protruding through the joining bars.
5. Fully tighten the nut and bolts with the heater
set at the desired angle shown below.
• SOR 15 ONLY - When vertically mounting,
ensure the mounting surface is angled so
the heater projects downwards. Do not
position the heater at an angle more than
45° and less than 30° to the horizontal as
shown below. Position the heater so the cord
is exiting the terminal box pointing down.
in
doubt
contact
a