AmbiSonic Systems D3200 Benutzerhandbuch - Seite 16

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken AmbiSonic Systems D3200 herunter. AmbiSonic Systems D3200 19 Seiten.

POWER AMP SPECIFICATIONS:

Frequency response (Ch2/Ch3 at 4/8 Ω load): 20 Hz - 20 kHz ± 0.1 dB / [20 Hz - 20 kHz ± 0.2 dB]

THD+N (AES17 filter) 1kHz, 1W, RL = 8Ω 0,003%

Signal-to-Noise Ratio (A-weighted, 20 Hz - 20 kHz, 8 Ω load) > 120 dB

Dynamic Range, Un-weighted/ Weighted 118dB / 120dB

Intermodulation distortion (CCIF), Ch2/Ch3, 18kHz/19kHz Po = 10W, 8Ω 0.0008% [0.001%]

Transient Intermodulation distortion (TIM), Ch2/Ch3, Po = 10W, 8Ω 0.002% [0.003%]

Damping factor (Ch2/Ch3 at 8 Ω load, 1 kHz and below): > 1000 [>500]

Protection Circuits: Input limiter, short circuit protection, DC protection of output, under &

over voltage protection, intelligent on-board mains fuse protection, power stage overload

protection, temperature protection.

NOTE: [specs for Channel 1]

DSP FEATURES AND SPECIFICATIONS:

● Mixed-mode 64 bits digital processing

● Up to 96kHz sample rate, 24 bit conversion

● Frequency range 10Hz - 40kHz

● 120dB dynamic range

● Ethernet control interface

● Real-time configuration and monitoring via PC/MAC with numerical and graphic controls

● Front panel LCD display with controls and signal level LEDs

● 100 programmable presets, password protected access levels

● 10 parametric filters on each input and output ( Bell, Shelving, Notch, HPF, LPF or Allpass filters)

● 1s delay on each input; 20ms delay on each output

● Butterworth, Bessel, Linkwitz-Riley filters up to 24dB/oct

● Zero-attack limiter and configurable true RMS compressor on each input and each output

● 180° phase control on each output

● Latency 600 microseconds only

● Advanced grouping functions

● Optional IOS application control

Specifications Continued

*All specifications are subject to change