AmbiSonic Systems D3200 Manual del usuario - Página 16
Navegue en línea o descargue pdf Manual del usuario para Amplificador AmbiSonic Systems D3200. AmbiSonic Systems D3200 19 páginas.
POWER AMP SPECIFICATIONS:
Frequency response (Ch2/Ch3 at 4/8 Ω load): 20 Hz - 20 kHz ± 0.1 dB / [20 Hz - 20 kHz ± 0.2 dB]
THD+N (AES17 filter) 1kHz, 1W, RL = 8Ω 0,003%
Signal-to-Noise Ratio (A-weighted, 20 Hz - 20 kHz, 8 Ω load) > 120 dB
Dynamic Range, Un-weighted/ Weighted 118dB / 120dB
Intermodulation distortion (CCIF), Ch2/Ch3, 18kHz/19kHz Po = 10W, 8Ω 0.0008% [0.001%]
Transient Intermodulation distortion (TIM), Ch2/Ch3, Po = 10W, 8Ω 0.002% [0.003%]
Damping factor (Ch2/Ch3 at 8 Ω load, 1 kHz and below): > 1000 [>500]
Protection Circuits: Input limiter, short circuit protection, DC protection of output, under &
over voltage protection, intelligent on-board mains fuse protection, power stage overload
protection, temperature protection.
NOTE: [specs for Channel 1]
DSP FEATURES AND SPECIFICATIONS:
● Mixed-mode 64 bits digital processing
● Up to 96kHz sample rate, 24 bit conversion
● Frequency range 10Hz - 40kHz
● 120dB dynamic range
● Ethernet control interface
● Real-time configuration and monitoring via PC/MAC with numerical and graphic controls
● Front panel LCD display with controls and signal level LEDs
● 100 programmable presets, password protected access levels
● 10 parametric filters on each input and output ( Bell, Shelving, Notch, HPF, LPF or Allpass filters)
● 1s delay on each input; 20ms delay on each output
● Butterworth, Bessel, Linkwitz-Riley filters up to 24dB/oct
● Zero-attack limiter and configurable true RMS compressor on each input and each output
● 180° phase control on each output
● Latency 600 microseconds only
● Advanced grouping functions
● Optional IOS application control
Specifications Continued
*All specifications are subject to change