Amcrest AMC4KBC36P-W Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitskamera Amcrest AMC4KBC36P-W herunter. Amcrest AMC4KBC36P-W 9 Seiten. 4k analog hdcvi bullet camera

Seite drucken

Note: The wall anchors should be in the same bag as the screws and a designed to secure the screws onto the

mounting surface.

Attach the power cable and BNC cabling to the camera. (If you are running the cables through a mounting

surface, use a 1" paddle bit to bore a hole for the cables.)

Place the base of the camera on the wall anchors lining the holes to the mounting surface. Then, using a

Phillips head screwdriver, secure the screws and base of the camera to the mounting surface.

Note: To adjust the camera, you can loosen the adjustment screws near the base of the camera. Adjust the

position as desired and tighten when complete.

Connection

To connect your camera to your DVR, please follow the steps provided below:

Step 1: Connect a BNC (coaxial) cable to the video out connection of your camera.

Step 2: Connect the male end of the DC power connector of the BNC (coaxial) cable to the female end of the power

connector of the camera.

Step 3: Connect the BNC (coaxial) cable to a video out channel on the back of your DVR.

Step 4: Connect the male end of the DC power connector of the power adapter to the female end of the power

connector of the BNC (coaxial) cable. Plug in the power adapter to apply power to the camera.

For more information on the installation process described, refer to the image below for more details.

Audio

The camera has a built-in microphone which allows the camera to transmit one-way audio through a coaxial

connection. To enable the microphone on your camera, please make sure the following settings on your DVR are

enabled.

In the Management menu, click on Encode to enter the encode settings menu for your DVR.

Click on "More Settings" and make sure that the Audio Encode checkbox is enabled.

Set the encode settings to AAC and then change the input from "Local" to "HDCVI".

Click Save to save the encode settings to your device.

Note: If you are using the system on your mobile device, ensure that the Video Steam checkbox is enabled in the

Sub stream menu of your DVR.

Using an Amcrest 4-in-1 Camera

Quadbrid or 4-in-1 technology, allows for a flexible means of providing HD-CVI, HD-TVI, AHD, and Analog

formatted video to your DVR. The signal is transmitted uncompressed, which eliminates latency and allows for

real-time, highly reliable video security without loss or delay. The cameras connect point-to-point directly to the

DVR (BNC) which provides a highly secure, closed network, as well as a painless and non-complex plug-and-play

setup process. The toggle switch for your 4-in-1 camera is represented in the image below: