Aktakom APS-7306 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Stromversorgung Aktakom APS-7306 herunter. Aktakom APS-7306 12 Seiten. Programmable dc power supply

Seite drucken

o For use in constant voltage mode: this is the desired current

limit.

o For use in constant current mode: this is the desired constant

current.

o If you enable overcurrent protection, the output switches

off automatically if the current exceeds this value.

4. Turn the adjustment knob [11] until you reach approximately the

desired current. Press [11] to select a digit in the current readout [10]

and turn the adjustment knob to fine-tune.

5. Press the memory key [3] again (or wait until the display to start

flashing). Then press the m1-m3 button The settings are saved in the

selected memory.( the display stops flashing)

Recalling Settings

To recall one of the saved settings, press the corresponding memory key

M1~M3 [4]. the corresponding voltage/current settings appear on the

display.

Note: the output is switched off automatically when you press a

memory key to recall a setup.

Using Memory 3

To use memory 3, proceed as follows:

1. Set the voltage and current as desired Press memory key [3],Wait

until the display start to flashing. Then Press key [4] the settings are

automatically stored in memory, and until the display stops to flashing.

2. To recall the settings, press key 4.

Connecting a Load

1. Connect the load's positive terminal to the red + terminal [14] of the

power supply.

2. Connect the load's negative terminal to the black – terminal [12]

of the power supply.

3. You can connect the + or – terminal to the green earth terminal

[13] of the power supply to pin the voltage to 0V (earth potential)

at that terminal.

If you leave the earth terminal unconnected, the output floats with

respect to the ground.