BOBPERRY AUDIO Ducker Pro 2 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Monitor BOBPERRY AUDIO Ducker Pro 2 herunter. BOBPERRY AUDIO Ducker Pro 2 18 Seiten.

Bob Perry Ducker Pro 2 – Manual – Page 9/18

SHOW ADVANCED CONTROLS

Extends the Advanced Controls Drawer to reveal the following additional controls:

INPUT GAIN + Input Meter

Adjusts the main input signal's level if a plug-in in the signal chain has a high or low output.

Most of the time you won't need to use it. It will take a very high level (>1500 dB) to create

distortion within the Ducker.

The meter to the left of the INPUT GAIN dial displays the plug-in's main input volume.

I/O GAIN LINK

If you want to alter the gain for use inside the plug-in, but want to revert the gain change by

the plug-in's output, you can enable I/O GAIN LINK. This will link INPUT GAIN and OUTPUT

GAIN, so that the OUTPUT GAIN will always represent the negative / inverted value of INPUT

GAIN, and vice versa.

ATTACK/HOLD/RELEASE X10

Multiplies the corresponding time parameter by 10. This allows you to set time values of up to

10 seconds.

Tip: You can use high values for triggering fadeouts.

M/S MATRIX

Switches Mid/Side modes (NORM (Stereo) / MID / SIDE) for the Main and Aux signals.

AUX M/S Switch: Sets which signal shall trigger the ducker.

MAIN M/S Switch: Sets which signal shall be modified by the ducker.

Examples: You can duck only the mid signal in a stereo track by switching the Main switch to

MID. If you want only the side signal of your side chain to be your trigger signal, switch the

Aux-Signal to SIDE.

Advice: Don't use the M/S Matrix if you only have mono signals or stereo signals with the same

signal on the left and right channels, as mono signals don't have a side signal.

Hint: "Side Signal" and "Side Chain" are two completely different things.

VST is a software and trademark of Steinberg Media Technologies GmbH.

20210113160816