Canon AE-1 Handbuch für Installationsverfahren - Seite 41
Blättern Sie online oder laden Sie pdf Handbuch für Installationsverfahren für Digitalkamera Canon AE-1 herunter. Canon AE-1 48 Seiten.
Auch für Canon AE-1: Erste Schritte (2 seiten), Anleitung Handbuch (22 seiten), Handbuch (42 seiten), Handbuch (12 seiten), Anleitung Handbuch (22 seiten)
Seite drucken
<Saddle Finisher-AE2>
<Saddle Finisher-AE2>
Detach the cable cover [I], and remove the six screws
Connect it to the connectors 5804 [I] and 5805 [2] of
[2]; then, detach the rear cover [3].
the saddle drive PCB; then, route the connector cable
through the two cable clamps [3], and fix it in place.
7) If the rubber sheet [l] that comes with the buffer
6) Securely fit the connector cable of the puncher unit
path unit is not already attached, attach it by refer-
to the two connectors on the PCB of the finisher.
ring to the rib [2] found on the right side of the
puncher unit.
A
Check to be sure that the connector is in firm con-
tact. If the puncher unit malfunctions after installa-
tion, disconnect and then connect the connector and
run a check.
the finisher controller PCB.
8) Mount the finisher's rear cover and the cable cover.
9) Mount the rear small cover of the finisher using a
screw.