DOMPEL ANDES TABLE Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Inneneinrichtung DOMPEL ANDES TABLE herunter. DOMPEL ANDES TABLE 6 Seiten.

ENGLISH

LOCATION OF INSTALLATION

Install your Dompel product in a level place with no grooves or splices,

preventing rocking and vibration. The location must be airy and it must not

allow straight sunlight and it must be away from sources of heat (stoves,

ovens, etc.) and ﬂammable products. Do not install your product outdoors.

CLEANING AND MAINTENANCE

Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,

thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.

To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical products

reach the upholstery, clean as soon as possible, preventing the products from staining or drying the fabric. The

plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry

ﬂannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case perform the

task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust aﬀects the beauty

of the product making it di翿 cult to clean the product.

IMPORTANT

Never drag the product, if necessary, ask other person's help to remove the product from the place. Do

not place containers with high temperature on your product, at the risk of damaging plastic parts or the

upholstery.

INSTALLATION AND ASSEMBLY

Remove all volumes from the package, and follow the steps below.

Support the top (B) on the ﬂoor or on a table/stand

to facilitate assembly (use a protection to avoid

scratching). Position the side structures (A) aligning

the pre-holes at the bottom of the top and then ﬁx

the screws/washers (E) using a spanner 10. Check

the tightness of the screws to ensure the ﬁrmness

of the assembled product.

Fasten the structural bar (C) to the side structure

(A). Position the screws/nuts/washers (F) and

tighten them using a 10 spanner.

Merely illustrative images.

Products may suﬀer changes in its components without prior warning. If any questions, contact Dompel.

SECURITY

Avoid accidents. After

unpacking the product, keep

all the pack material out of

children's reach.

Manually position the structural bar (C) between

the side structures (A) aligning the holes.

Manually ﬁt the drawers (D) into the rails under the

top (B). The ﬁtting, movement and access of the

drawers will take place on both sides. Important!

To ensure maximum load safety, distribute the

weight evenly over the support areas.