DOMPEL ANDES TABLE Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Indoor Furnishing DOMPEL ANDES TABLE. DOMPEL ANDES TABLE 6 pages.

Print Page
ENGLISH
LOCATION OF INSTALLATION
Install your Dompel product in a level place with no grooves or splices,
preventing rocking and vibration. The location must be airy and it must not
allow straight sunlight and it must be away from sources of heat (stoves,
ovens, etc.) and flammable products. Do not install your product outdoors.
CLEANING AND MAINTENANCE
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,
thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical products
reach the upholstery, clean as soon as possible, preventing the products from staining or drying the fabric. The
plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry
flannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case perform the
task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust affects the beauty
of the product making it di翿 cult to clean the product.
IMPORTANT
Never drag the product, if necessary, ask other person's help to remove the product from the place. Do
not place containers with high temperature on your product, at the risk of damaging plastic parts or the
upholstery.

INSTALLATION AND ASSEMBLY

Remove all volumes from the package, and follow the steps below.
1
Support the top (B) on the floor or on a table/stand
to facilitate assembly (use a protection to avoid
scratching). Position the side structures (A) aligning
the pre-holes at the bottom of the top and then fix
the screws/washers (E) using a spanner 10. Check
the tightness of the screws to ensure the firmness
of the assembled product.
3
Fasten the structural bar (C) to the side structure
(A). Position the screws/nuts/washers (F) and
tighten them using a 10 spanner.
Merely illustrative images.
Products may suffer changes in its components without prior warning. If any questions, contact Dompel.
SECURITY
Avoid accidents. After
unpacking the product, keep
all the pack material out of
children's reach.
2
Manually position the structural bar (C) between
the side structures (A) aligning the holes.
4
Manually fit the drawers (D) into the rails under the
top (B). The fitting, movement and access of the
drawers will take place on both sides. Important!
To ensure maximum load safety, distribute the
weight evenly over the support areas.